Cell adhesion, migration, and proliferation are significantly affected by the surface topography of the substrates on which the cells are cultured. Alumina is one of the most popular implant materials used in orthopedics, but few data are available concerning the cellular responses of mesenchymal stem cells (MSCs) grown on nanoporous structures. MSCs were cultured on smooth alumina substrates a...

Mesoporous alumina catalysts that incorporate nickel (Ni-Alumina) with different Ni/Al molar ratios of 1:2, 1:5 and 1:10 were synthesized by a one-step sol–gel method using lauric acid as a template. The prepared Ni-Alumina catalysts showed a relatively high surface area with a narrow pore size distribution after calcination at 700 ◦C; these effects were independent of the Ni/Al molar ratio. Al...

abstract: this paper presents the results of studies concerned with the preparation of fresh food foams based on egg white and various hydrocolloids including iranian gum tragacanth, guar and xanthan gums at different concentrations (0.002-0.040% w/w). the basic physical parameters of the obtained foams such as overrun, stability and morphology of gas bubbles were measured. viscosity measuremen...

Nanoporous alumina membranes exhibit high pore densities, well-controlled and uniform pore sizes, as well as straight pores. Owing to these unusual properties, nanoporous alumina membranes are currently being considered for use in implantable sensor membranes and water purification membranes. Atomic layer deposition is a thin-film growth process that may be used to modify the pore size in a nan...

The paper reports a process for synthesis of γ-alumina from kaolin. Kaolin was transformed to meta-kaolin by calcination at 800 ̊C for 2h. γ-alumina powder was synthesized through extracting alumina from metakaolin via H2SO4 and meta-kaolin reactions and consequently precipitation in ethanol, which led to form the aluminum sulfate. The precipitated aluminum sulfate was dried and calcined at 900 ̊...

Many pioneers from around the world followed this initial experience but long-term results and good methodology were lacking. Recently, a number of reports 4-6 have focused attention again on an alumina-on-alumina combination. More than 30 years after its introduction into clinical practice, this article considers the current information on the alumina-on-alumina combination from both experimen...

A new rapid, very simple and one-step sol-gel strategy for the large-scale preparation of highly porous γ-Al₂O₃ is presented. The resulting mesoporous alumina materials feature high surface areas (400 m² g-1), large pore volumes (0.8 mL g-1) and the γ-Al₂O₃ phase is obtained at low temperature (500 °C). The main advantages and drawbacks of different preparations of mesoporous alumina materials ...

Monolithic ceramics have been fabricated from coated green fibers to create fibrous microstructures. The fibrous monoliths consist of high aspect ratio polycrystalline regions (cells) of a primary phase separated by thin secondphase regions (cell boundaries) designed to improve fracture resistance. The cells are the remnants of the green fiber which consists of ceramic powder and a polymer bind...

The brass tubes with foam cores of AlSi7SiC3, AlSi7SiC3Fe1 and AlSi7SiC3Fe3 were produced as the crush-boxes with circle and square cross-section. Then axial compressive behavior and energy absorption capability of the foam-filled tubes were investigated during the quasi-static progressive plastic buckling. The uniaxial compressive stress–strain curves of the foam-filled brass tubes exhibited t...

Foam injection is widely applied in amounts of fields to drilling, production, and formation protection. Sometimes, the application result is disappointing, which is caused by the failure of bubble generation in foam flooding. Therefore, it is necessary to seek ways for improving the performance of foam injection. An increased disturbance to the stratum, like the vibration caused by a seismic o...