The influence of zirconium on the grain refinement of Al 6063 alloy has been experimentally investigated. The microstructure and macrostructure of the refined alloy were investigated. The experimental results reveal that, the coarse dendrites in the microstructure of the alloy are effectively refined with the addition of zirconium to the melt prior to solidification. Grains of Al 6063 alloy can...

© 2016 The Author(s). Published by Taylor & Francis on behalf of the Nordic Orthopedic Federation. This is an Open Access article distributed under the terms of the Creative Commons Attribution-Non-Commercial License (https://creativecommons.org/licenses/by-nc/3.0) DOI 10.3109/17453674.2015.1128780 (McGrory et al. 2015, Bishop et al. 2013). No mechanical implant failures (i.e. fractures) have b...

Taking Al–Li–S4–T8 Al–Li alloy as the study object, based on the stretching and deforming characteristics of sheet metals, this paper proposes a new approach of critical orange peel state characterizations on the basis of the precise measurement of stretch-forming surface roughness and establishes the critical criterion for the occurrence of orange peel surface defects in the stretch-forming pr...

In this paper, the relationship between the liquid structure and the corresponding solidified microstructure of an Al-Si-Mg-P alloy was studied. Experimental results show that Mg can reduce the phosphorous-modification effect if it was added after adding Al-P alloy. However, when it is added before adding Al-P alloy, Mg has no effect on the phosphorous-modification. It is considered that the di...

The paper deals with the optimization of welding parameters of friction stir welding of different Aluminium alloy groups. For this purpose 5 series Aluminium alloy Al 5083 and 6 series Aluminium alloy Al 6062 were taken .Tensile Strength test and micro structure analysis under various rotating speeds and tool profiles is conducted. It is observed that the increase in tool rotation speed and the...

During heat treatment, the work piece experiences a range of heating rates depending upon the sizes and types of furnace. When the Al-Si-Mg cast alloy is heated to the solutionizing temperature , recrystallization takes place during the ramp-up stage. The effect of heating rate on recrystallization in the A356 (Al-Si-Mg) alloy was studied using dilatometric and calorimetric methods. Recrystalli...

The paper studies the influence of magnetic field on magnetic and mechanical properties of Cu-Mn-Al alloy under annealing. The comparative analysis of the magnetic field orientation impact on solid solution decomposition processes in a fixed annealing procedure is held using the methods of low-field magnetic susceptibility, specific magnetization, and microhardness test. The paper highlights ch...

Thermal stability and the kinetics of the grain growth of nano-crystalline Mg-6Al-1Zn-1Si alloy prepared via mechanical alloying (MA) were investigated. It started with elemental powders, using a variety of analytical techniques including differential scanning calorimetry (DSC), X-ray diffraction method (XRD), and scanning electron microscopy (SEM) coupled with energy dispersive spectrometry (E...

The effect of the milling time & ageing on the hardness, density, and wear characteristics of Al 7150 alloy specimens made via powder metallurgy has been studied. The different constituents of Al 7150 alloy were processed in a planetary ball milling set up with a BPR of 10:1 for 5 hours, 10 hours, and 20 hours. At 400 °C, the milled powders were subsequently hot compacted in a punch die setup. ...

The effects of Zr additive on the microstructure, mechanical properties, and fracture behavior of Al-Si alloy were systematically investigated. The additive of Zr obviously reduced the size of Si particles and changed its morphology. Grain size refinement was promoted by the reaction between Al and Zr forming Al3Zr and ZrSi2 compounds. Compared to a Zr-free alloy, the additive enhanced the tens...