A metallurgical zirconium nitride (ZrN) layer was fabricated using glow metallurgy using nitriding with zirconiuming prior treatment of the Ti6Al4V alloy. The microstructure, composition and microhardness of the corresponding layer were studied. The influence of this treatment on fretting wear (FW) and fretting fatigue (FF) behavior of the Ti6Al4V alloy was studied. The composite layer consiste...

The phase analysis of Cu-0.41%Cr-0.20%Zr alloy treated by vacuum melting + solid solution aging was carried out means SEM, TEM, EDXS and XRD. results show that there are three phases in the alloy, namely copper matrix phase, chrome-rich zirconium-rich phase. distribution size is bimodal. coarse microns scale, main components elemental chromium Cu 5 Zr, which formed during casting process not ea...

Zirconium (Zr) is an important alloying element to Mg-Zn-based alloy system. In this paper, we report the formation of the β-type precipitates on the nanoscale Zr-rich particles in a Mg-6Zn-0.5Cu-0.6Zr alloy during ageing at 180°C. Scanning transmission electron microscopy examinations revealed that the nanoscale Zr-rich [0001]α rods/laths are dominant in the Zr-rich core regions of the as-quen...

With the rapid development of economic, gypsum is widely used in casting and other industry areas. In this paper, the result is obtained that the performance of plaster mold is better when gypsum-water ratio is 0.5. If the composition of gypsum slurry mixture ( -hemihydrate, mullite powder, zirconium powder, reinforcing fibers) is mullite powder: zircon flour: enhancing fiber = 1:0.25:0.2:0.02-...

The classical wear mechanisms abrasion, fatigue, and adhesion are the most frequent causes of surface changes of ultra high molecular weight polyethylene (UHMWPE) in artificial joints. The counterpart material has a strong influence on the wear and friction behavior of artificial joints due to its abrasive properties and adhesive interaction with UHMWPE. The formation of a transfer layer on the...

The impact of wear factors on composite materials is examined in this article. Stir casting was used to produce AA7075 alloys with varied nano-zirconium boride weight ratios. dry sliding test done utilizing pin-on-disc equipment. L27 orthogonal array built by Taguchi’s experiments for optimization. We calculated the proportion responses that could be attributed input parameters using SNR and AN...

The corrosion behavior of the fusion zone of gas tungsten arc (GTA) welds of AA6061 alloy was studied. Role of gas tungsten arc welding techniques such as continuous current (CC) and pulsed current (PC) and reference filler (AA5356) were studied. Role of different grain refiners such as scandium, zirconium and Tibor in the reference filler was studied. Dynamic polarization testing was used to d...

Monophase thorium–zirconium hydrides (ThZr2Hx) have been fabricated starting from a metallic alloy and the hydrogen stoichiometry determined by X-ray diffraction. Incoherent Quasielastic Neutron Scattering (IQNS) on the hydrides was conducted over the temperature range 650–750 K at the Backscattering Silicon Spectrometer (BASIS) at the Spallation Neutron Source (SNS) at ORNL. The isotropic Chud...

Feasibility tests were initiated to determine if the zirconium in commercial used nuclear fuel (UNF) cladding can be recovered in sufficient purity to permit re-use, and if the recovery process can be operated economically. Initial tests are being performed with unirradiated, non-radioactive samples of various types of Zircaloy materials that are used in UNF cladding to develop the recovery pro...