The thermal performances of a minichannel heat sink are experimentally investigated for cooling of electronics using nanofluid coolant instead of pure water. The Al2O3–H2O nanofluid including the volume fraction ranging from 0.10 to 0.25 vol.% was used as a coolant. The effects of different flow rates of the coolant on the overall thermal performances are also investigated. The flow rate was ra...

Nanofluid has great potentials in heat transfer enhancement and entropy generation decrease as an effective cooling medium. Effects of Al2O3-water nanofluid flow on entropy generation and heat transfer performance in a rectangular conventional channel are numerically investigated in this study. Four different volume fractions are considered and the boundary condition with a constant heat flux i...

in this paper, overall heat transfer coefficient and friction factor of water based γ-al2o3 nanofluid in a double tube counter flow heat exchanger have been measured experimentally under turbulent flow condition. for better dispersion of γ-al2o3 nanoparticles in distilled water, magnetic stirrer and ultrasonic vibrator (with a power of 240 kw and frequency of 35 khz) were implemented. the stabi...

A lattice Boltzmann model is developed by coupling the density (D2Q9) and the temperature distribution functions with 9-speed to simulate the convection heat transfer utilizing Al2O3-water nanofluids in a square cavity. This model is validated by comparing numerical simulation and experimental results over a wide range of Rayleigh numbers. Numerical results show a satisfactory agreement between...

The abrasion is a significant issue, especially in machining of rigid steels. A functional and suitable approach for enhancing the heat transfer from machining area is using an intermediate fluid with higher heat transfer potential instead of common fluids. The objective of this experimental study is to discuss production, stability and thermal conductivity examination of water/graphene oxide n...

Experiments are undertaken to determine the efficiency of an evacuated tube solar collector using water-based Titanium Oxide (TiO2) nanofluid at the Pekan Campus (3 ̊32’ N, 103 ̊25’ E), Faculty of Mechanical Engineering, University Malaysia Pahang, for the conversion of solar thermal energy. Malaysia lies in the equatorial zone with an average daily solar insolation of more than 900 W/m2, which c...

It is necessary to control the temperature of solar cells for enhancing efficiency with increasing concentrations of multiple photovoltaic systems. A heterogeneous two-phase model was established after considering the interacting between temperature, viscosity, the flow of nanofluid, and the motion of nanoparticles in the nanofluid, in order to study the microchannel heat sink (MCHS) using Al2O...

In this study the performances of various non-circular microchannel heat sinks (normalized with circular shape) have been comparatively analyzed for CuO-water nanofluid and baseline pure water flow. Nusselt number and Poiseuille number for each microchannel and thermo-physical properties of CuO-water nanofluid (viz., thermal conductivity, viscosity, specific heat and density) have been designed...

The entropy generation based on the second law of thermodynamics is investigated for turbulent forced convection flow of ZrO2-water nanofluid through a square pipe with constant wall heat flux. Effects of different particle concentrations, inlet conditions and particle sizes on entropy generation of ZrO2-water nanofluid are studied. Contributions from frictional and thermal entropy generations ...

This study compares environmental and economic impacts of using nanofluids to enhance solar collector efficiency as compared to conventional solar collectors for domestic hotwater systems. Results show that for the current cost of nanoparticles the nanofluid based solar collector has a slightly longer payback period but at the end of its useful life has the same economic savings as a convention...