Self-similar fractals are useful models of the soil solid and pore sets along lines, across areas and inside volumes. The scaling properties of these sets, analysed by the divider method within the known scale range over which the fractal extends, were described by three parameters, the solid (Ds) and pore (Dp) linear box or capacity empirical fractal dimensions, and the total number of rulers ...

Hydroxyapatite scaffolds with a multi modal porosity designed for use in tissue engineering of vascularized bone graft substitutes were prepared by three dimensional printing. Depending on the ratio of coarse (mean particle size 50 microm) to fine powder (mean particle size 4 microm) in the powder granulate and the sintering temperature total porosity was varied from 30% to 64%. While macroscop...

This study focuses on the effects of elevated building substructure porosity on the accumulation of drifting snow. We conducted wind tunnel experiments of the snowdrift accumulation and numerical simulations to determine the flow field around a prototypical elevated building (based on the Martin A. Pomerantz Observatory or MAPO) with varying substructure porosity. We found that the total drift ...

With a shift to exploiting unconventional petroleum plays in the United States to support energy consumption, understanding the nanopore systems in those unconventional resources becomes important for future exploitation. The goal of this study is to characterize the pore systems of the Cretaceous Lincoln Limestone found in the Denver-Julesburg (DJ) Basin in order to test the hypothesis that li...

The in vivo enrichment of dendritic cells (DCs) in implanted macroporous scaffolds is an emerging strategy to modulate the adaptive immune system. The pore architecture is potentially one of the key factors in controlling enrichment of DCs. However, there have been few studies examining the effects of scaffold pore structure on in vivo DC enrichment. Here we present the effects of surface poros...

The effect of degree of compression on the evolution of tablet microstructure and bond probability during compression of granular solids has been studied. Microcrystalline cellulose pellets of low (about 11%) and of high (about 32%) porosity were used. Tablets were compacted at 50, 100 and 150 MPa applied pressures and the degree of compression and the tensile strength of the tablets determined...

A self-developed rotary multi-cutter device cuts stainless steel wire ropes into segments to fabricate twisted wires. Stainless steel porous twisted wire materials (PTWMs) with a spatial composite intertexture structure are produced by the compaction and subsequent vacuum solid-phase sintering of twisted wires. The stainless steel PTWMs show two types of typical uniaxial tensile failure modes, ...

This in vitro investigation of the behavior of two types of calcium phosphate glass ceramics on the basis of phosphates of biogenic or synthetic origin prepared from initial mixtures with different particle size has revealed that some different factors affect the behavior, namely the phase composition of composite, fraction of open porosity, and average diameter of pore channels. It was establi...

In this paper, the effects of carbonation on pore structure of blended pozzolan cement pastes were investigated. Ordinary Portland cement OPC was partially replaced with ground palm oil fuel ash POA , ground rice husk ash RHA and classified fine fly ash FA . The strength, total porosity, specific surface area, and pore size distribution were tested. In general, incorporation of pozzolans increa...

The present work concerns the calculation of the infinitesimal porosity by using the Menger’s Sponge model. This computation is based on the grossone theory considering the pore volume estimation for the Menger’s Sponge and afterwards the classical definition of the porosity, given by the ratio between the volume of voids and the total volume (voids plus solid phase). The aim is to investigate ...