Long term tensile creep studies were conducted on binary NiAl in the temperature range 700-1200 K with the objectives of characterizing and understanding the creep mechanisms. Inverse and normal primary creep curves were observed depending on stress and temperature. It is concluded that the primary creep of NiAl is limited by dislocation mobility. The stress exponent for creep, n, decreased fro...

Commercial, aluminum die-cast alloys are subject to long-term stresses leading to viscoelastic material responses resulting in inefficient engine operation and failure. Constant load creep tests were conducted on aluminum die-casting alloys: B-390, eutectic Al-Si and a 17% Si-Al alloys. Rupture occurred in the primary creep regime, with the eutectic alloy having the longest times to failure. Pr...

Existing design guidelines for concrete hinges consider bending-induced tensile cracking, but the structural behavior is oversimplified to be time-independent. This is the motivation to study creep and bending-induced tensile cracking of initially monolithic concrete hinges systematically. Material tests on plain concrete specimens and structural tests on marginally reinforced concrete hinges a...

Creep is a time-dependent viscoelastic deformation observed under a constant prolonged load. It has been indicated that progressive vertebral deformation due to creep may increase the risk of vertebral fracture in the long-term. The objective of this study was to examine the relationships of creep with trabecular architecture and tissue mineral density (TMD) parameters in human vertebral cancel...

To capture the mechanical response of Ni-based materials, creep deformation and rupture experiments are typically performed. Long term tests, mimicking service conditions at 10,000 h or more, are generally avoided due to expense. Phenomenological models such as the classical Kachanov–Rabotnov (Rabotnov, 1969, Creep Problems in Structural Members, North-Holland, Amsterdam; Kachanov, 1958, “Time ...

Tensile and creep properties of new austenitic steel Sanicro 25 at room temperature and operating temperature 700 °C were investigated by testing on miniature specimens. The results were correlated with testing on conventional specimens. Very good agreement of results was obtained, namely in yield and ultimate strength, as well as short-term creep properties. Although the creep rupture time was...

Cartilage material properties provide important insights into joint health, and cartilage material models are used in whole-joint finite element models. Although the biphasic model representing experimental creep indentation tests is commonly used to characterize cartilage, cartilage short-term response to loading is generally not characterized using the biphasic model. The purpose of this stud...

The aim of this project was to see whether the tendon would show creep during long-term dynamic loading (here referred to as dynamic creep). Pig tendons were loaded by a material-testing machine with a human Achilles tendon force profile (1.37 Hz, 3% strain, 1,600 cycles), which was obtained in an earlier in vivo experiment during running. All the pig tendons showed some dynamic creep during cy...

It is crucial for the carbon concentration of 9% Cr steel to be reduced to a very low level, so as to promote the formation of MX nitrides rich in vanadium as very fine and thermally stable particles to enable prolonged periods of exposure at elevated temperatures and also to eliminate Cr-rich carbides M23C6. Sub-boundary hardening, which is inversely proportional to the width of laths and bloc...

The Non-Linear Strain Energy Equivalence Theory, a semi-empirical model, is utilized to predict longterm creep from short-term compressive stress-strain experiments conducted at different strain rates. Stress-strain experiments in uni-axial compression are performed at strain rates of 3 and 0.03 %/minute to predict creep behavior and stress-strain data at several strain rates for an immiscible ...