The engineering tension test is widely used to provide basic design information on the strength of materials and as an acceptance test for the specification of materials. In the tension test a specimen is subjected to a continually increasing uniaxial tensile force while simultaneous observations are made of the elongation of the specimen. The parameters, which are used to describe the stress-s...

Transport of colloids with transient wetting fronts represents an important mechanism of contaminant migration in the vadose zone. The work presented here used steady-state saturated and transient unsaturated flow columns to evaluate the transport of a fluorescent latex microsphere (980 nm in diameter) with capillary wetting fronts of different solution surface tensions and ionic strengths. The...

The aim of this study is to determine the change of some physical properties (oven-dry density, weight loss, swelling and anti-swelling efficiency) and mechanical properties (compression strength parallel to grain, bending strength, modulus of elasticity in bending, janka-hardness (cross-section, radial, tangential), impact bending strength and tension strength perpendicular to grain) of wild c...

We report a novel surface-tension driven instability observed for droplets spreading on a compliant substrate. When a droplet is released on the surface of an agar gel, it forms arms or cracks when the ratio of surface-tension gradient to gel strength is sufficiently large. We explore a range of gel strengths and droplet surface tensions and find that the onset of the instability and the number...

Orientation and temperature dependence of yield stress or CRSS (Critical Resolved Shear Stress) and tension/compression anisotropy of the yield stress or CRSS have been shown by Shah and Duhl (1), Heredia and Pope (2), and Miner et al. (3). Tension/compression asymmetry in the yield strength of Ni-based superalloys has been explained in terms of the “core width effect” (4). Shah and Duhl (5) ob...

This study compares the functional capabilities of different metacarpal fixation constructs under physiological loadings in an attempt to identify the optimal construct rather than the strongest one. One hundred and twenty-six preserved human metacarpals were mechanically tested after oblique osteotomies and internal fixation. Maximum load to failure, average structural rigidity, and energ...

Static and fatigue data available in literature concerning carbon fiber reinforced composite laminates subjected tension-tension fatigue were re-elaborated in the framework of a two-parameter fatigue model explicitly accounting for the cyclic as well as the mean stress. The data were used to obtain the model parameters by best fitting procedures. A primitive statistical implementation of the mo...

To investigate the gradual failure of high-density polyethylene (HDPE) geomembrane as a result of long-term corrosion, four dynamic corrosion tests were conducted at different temperatures and durations. By combining tension and puncture tests, we systematically studied the variation law of tension and puncture properties of the HDPE geomembrane under different corrosion conditions. Results sho...

[1] This paper revisits the Arctic Ice Dynamics Joint Experiment (AIDJEX) assumptions about pack ice behavior with an eye to modeling sea ice dynamics. The AIDJEX assumptions were that (1) enough leads were present in a 100 km by 100 km region to make the ice isotropic on that scale; (2) the ice had no tensile strength; and (3) the ice behavior could be approximated by an isotropic yield surfac...

Carbon fibres can be used as structural electrodes because they have a high tensile properties-to-weight ratio and a graphitic structure which enables lithium-ion intercalation. Carbon fibre specimens were used as electrodes in laboratory cells. It was found that the fibre undergoes an ultimate tensile strength drop and an axial expansion which depend on the measured capacity. The results sugge...