In this paper, a compression-to-tensile load converter device is developed to determine the anisotropic tensile strength of brittle material. A cubic sample with an internal pore was used as the test specimen, and a series of finite element analysis and DDM simulations were performed thereafter to analyse the effect of pore dimensions on the stress concentration, as well as to render a suitable...

in this research formability behavior and texture of st14 low carbon steels produced by foolad mobarakeh plant for deep drawing application had been studied. plate textures were characterized by x-ray diffraction technique. to evaluate formability behavior one dimensional tensile test was carried out and related parameters were recognized. moreover eriksson experiment and spherical pattern prin...

In the new superconducting FAIR magnets, polyimide films (Kapton) will be used as insulator. During operation, the material is exposed to high-dose radiation and it has to withstand enormous mechanical forces induced by the magnet field ramping. For better lifetime estimation, this study investigates radiation-induced degradation of the mechanical properties of Kapton by tensile strength measur...

Polymer-based nanocomposites due to their advantages such as corrosion resistance,adequate mechanical properties and low cost are widely used in modern technologies. The increasing application of these nanocomposites, and hence their welding seems unavoidable. In this paper, a novel hottool in friction stir welding process is used for butt welding nanocomposite plates of 5 mm thick containing p...

Polyamide 6 / nitrile butadiene rubber / nanoclay (PA6/NBR/clay) nanocomposite has gathered wide acceptance in industry. Laser welding, as a fabrication method, is applied to welding of polymer nanocomposites. In this study, the input parameters (clay (Closite 30B) content, laser power, scan velocity and stand-off-distance) are varied to achieve the best responses (tensile strength of welds). R...

prior to the design and construction of any fruit harvesting machine it is essential to know the physical and mechanical properties of the trees and of its fruits. an example could be cited as the force needed to overcome. the strength with which the fruit is attached to the stem, in trunk shaker harvesting. in this research the acting forces on the fruit during harvest, including tensile stren...

The mechanical properties of titanium Grade 2 subjected to the hydrostatic extrusion technique (HE) were investigated. The hydrostatic extrusion technique is a method which refines the titanium grains to a nano-metric size. Compared with coarse grained titanium (CG-Ti), nanocrystalline titanium (NC-Ti) is characterized by a much higher yield stress, tensile strength and microhardness. The yield...

This Article contains errors in the insets of Figures 3(a), 3(b) and 3(c), where the stress values were incorrectly given as three times smaller than the correct GPa values. The correct Figure 3 appears below as Figure 1. As such, in the Results section, under subheading 'Strain modulated electronic structure. ' : " The Young's modulus along x, y and z directions can be evaluated to be 49.89 GP...