In situ synchrotron X-ray diffraction measurements are used to create two-dimensional maps of elastic strain and texture, averaged over a compact-tension specimen thickness, near a crack tip in a martensitic NiTi alloy. After fatigue crack propagation, the material ahead of the crack and in its wake exhibits a strong texture, which is eliminated by subsequent shape-memory heat treatment, indica...

When a femtosecond laser pulse is focused inside a LiF single crystal, four cracks are generated in the <100> directions from the photoexcited region. The time-resolved observation have elucidated that the tensile stress in the laser induced stress wave induces the generation and propagation of the cracks. In this study, to investigate the possibility of control of laser induced cracks inside s...

Abstract—A model to predict the plastic zone size for material under plane stress condition has been developed and verified experimentally. The developed model is a function of crack size, crack angle and material property (dislocation density). Simulation and validation results show that the model developed show good agreement with experimental results. Samples of low carbon steel (0.035%C) wi...

Debonding problems of externally bonded fiber reinforced polymer (FRP) sheets in flexurally FRP-strengthened reinforced concrete (RC) beams have been a concern and a research challenge since their application of this strengthening technique. Intermediate crack induced debonding is the most common failure mode which is that the debonding initiates at the critical flexural-shear or flexural crack...

The tensile creep behavior is extremely important in crack prediction and stress analysis of concrete. The main objective is investigating the effects of the silica fume on the tensile basic creep of early-aged concrete. The effect of silica fume on tensile creep was studied using lever-type tensile creep tester. Silica fume amount by weight of total cementing material was 0%, 5%, 10% and 15%. ...

This article describes a method for creating submicrometer surface patterns on cubes and microspheres. In this method, PDMS cubes and microspheres are exposed to oxygen plasma, which creates a very thin, hard, surface-modified layer on a compliant substrate. These are then compressed, causing the layer to crack in patterns dictated by the distribution of tensile stresses in the surface layer. C...

This effort explores the evolution and characterization of structural cracks in aircraft fuselage structures in which the loads are varying. During flight, an aircraft fuselage skin and structure are subjected to varied cyclic loads, which can cause embedded cracks and other damage features to change their characteristics due to loading effects. The current research uses finite element modeling...

Article history: Received 26 June 2016 Accepted 7 July 2016 Available online xxxx In the thin film transistors (TFTs) device research for foldable display, the degradation effect by the mechanical stress is crucial. Here, the crack position is critical for TFT reliability. However, it is difficult to characterize the crack position due to the random generation of the crack by mechanical stress....

A solution is given for the thermoelastic stress field due to the obstruction of a uniform heat flux by a plane crack in a generally anisotropic body. A Green's function formulation is used to reduce the problem to a set of singular integral equations which are solved in closed form. When the crack is assumed to be traction free, the crack opening displacement is found to be negative over one h...

A model has been created to allow the quantitative estimation of the fatigue crack growth rate in steels as a function of mechanical properties, test–specimen characteristics, stress–intensity range and test–frequency. With this design, the remarkable result is that the method which is based on steels, can be used without modification, and without any prior fatigue test, to estimate the crack g...