The use of static load testing in optimising design and providing verification of suitability and constructability continues to be unsurpassed in the foundation industry. The utilisation of top load reaction testing appears to be that with which most European engineers are familiar, but a variation on this, which has become just as conventional in some parts of the world, is the use of bi-direc...

The present study investigates the effect of de-sanding (recycling system) on bearing capacity bored piles. Full-scale models were conducted two groups piles, first group was implemented without using this system, and second recycling system. All piles tested by static load test, considering time factor for which implemented. test results indicated a significant clear difference in when use sys...

In order to study pressed pile test and ultimate bearing capacity character of large-diameter steel pipe pile, based on two high-piled wharfs of Zhanjiang Port, pressed pile test and numerical simulation of three large-diameter steel pipe piles are analyzed in this paper. Anchored pile method is used to pressed pile test, and the curves of Q-s and ultimate bearing capacity are attained. Then th...

Remediation of slope failures requires stabilization alternatives that address causes of slope instability. Slope reinforcement and pile stabilization systems, if properly designed, are effective in preventing slope movements in weak soils. Soil load transfer to pile elements from the lateral soil movement as occurs in slope failures is a complex soil-structure interaction problem, and the sign...

The massive construction in poor lands has encouraged engineers to use deep foundations in order to transfer superstructure loads to the subsoil. Since soil excavation, sampling, and laboratory testing as a part of site investigation are relatively difficult, in-situ tests such as cone penetration test (CPT) as a very informative test may be recommended. The CPT has been widely used in engineer...

This technical note presents the results of a field investigation into pile aging in soft clay which was conducted over a period of ten years. Static load tests were conducted after the excess pore pressure generated by the installation of 6 m long driven concrete piles were fully equalised. These tests allowed the time-capacity aging profile to be established. A normalised capacity-time trend ...

The reliability index is an important reliability parameter that is necessary for the development of reliability-based geotechnical design. Both the factor of safety (FS) and the reliability index (β) represent safety margin of structures against either failure or limit state. In this study, the reliability index is analyzed and evaluated in reference to the factor of safety currently adopted i...

ABSTRACT: The problem of lateral load induced on piles under earthquake has been plaguing professional engineers, geo-technical investigators and researchers alike for quite some time. The normal practice is to ensure that the fixed base shear of column does not exceed the static shear load capacity of piles. The inertial and stiffness effect of pile is usually ignored in dynamic earthquake ana...

this research examines the behavior of soil-reinforced piles and applied loads based on the analytical method and by using the numerical results of flac3d software for comparison with the analytical results. the analysis was based on a method called virtual retaining wall, the following into consideration: an imaginary retaining wall that passes the footing edge the bearing capacity of footing ...

Slope reinforcement and the use of structural pile elements can be an effective slope remediation alternative when conventional remediation practices (e.g., improved drainage) fail to consider the causal factors leading to slope instability (e.g., strength loss due to weathering). An experimental research program was aimed at developing a rapid, cost-effective, and simple remediation system tha...