Chip formation during dry turning of Ti6Al4V alloy has been examined in association with dynamic cutting force measurements under different cutting speeds, feed rates and depths of cut. Both continuous and segmented chip formation processes were observed in one cut under conditions of low cutting speed and large feed rate. The slipping angle in the segmented chip was 551, which was higher than ...

17-4PH stainless steel is a martensitic precipitation hardening stainless steel that provides an outstanding combination of high strength, good corrosion resistance, good mechanical properties, good toughness in both base metal and welds, and short time, low-temperature heat treatments that minimize warpage and scaling. This valuable alloy is widely used in the aerospace, nuclear, chemical, pet...

the current building codes provide limited prescriptive guidance on design for protection of buildings due to progressive collapse. progressive collapse is a situation in which a localized failure in a structure, caused by an abnormal load, such as explosions or other happenings. three procedures, often employed for determination of the structural response during progressive collapse i.e. linea...

It is very important to use reliable and inexpensive sensors to obtain useful information about manufacturing processing, such as cutting force, for monitoring automated machining. In this paper, the feed cutting force is measured using an inexpensive current sensor installed on the a.c. servo motor of a CNC turning centre. The factors that affect a feed drive system are analysed in detail, and...

This study investigated the machinability of experimental Ti-Ag alloys (5, 10, 20, and 30 mass% Ag) as a new dental titanium alloy candidate for CAD/CAM use. The alloys were slotted with a vertical milling machine and carbide square end mills under two cutting conditions. Machinability was evaluated through cutting force using a three-component force transducer fixed on the table of the milling...

In this research work a series of tests were conducted in order to determine flank wear and cutting force FY on hard AISI 440 C martensitic stainless steel and SCM 440 alloy steels. The operating parameters are cutting speed, feed rate and a constant depth of cut to investigate the flank wear and cutting force. No cutting fluid was used during the turning process. The cutting tool used was CBN ...

The mechanics of the cutting process on the microscopic level differ fundamentally from the conventional macro cutting. For example, the tool edge radius influences the cutting mechanism in micro machining significantly with regard to the effective rake angle, the minimum chip thickness, the dominance of ploughing, and the related elasto-plastic deformation of the workpiece material. These phen...

Optimization of process parameters is the key step in response surface methods to achieve high quality without cost inflation. The multi-response optimization of the machining parameters viz, chip-tool interface temperature, main cutting force and feed force on lathe turning of En-31 steel as alloy steel using RSM with grey relational analysis is reported. A grey relational grade obtained from ...