We observe a dependence of the damping of a confined mode of precessing ferromagnetic magnetization on the size of the mode. The micron-scale mode is created within an extended, unpatterned yttrium iron garnet film by means of the intense local dipolar field of a micromagnetic tip. We find that the damping of the confined mode scales like the surface-to-volume ratio of the mode, indicating an i...

We report the experimental measurement and simulation of the transient electrostatic pull-in characteristics of microstructural beams fabricated with silicon surface micromachining. Pull-in dynamics are investigated under the influence of compressible squeezed-film damping (CSQFD) for large amplitude motion. A linearized one-dimensional model, using a fitted damping constant, and a two-dimensio...

We consider squeeze film gas damping during microbeam motion away and toward a substrate as occurs during opening and closing of RF switches and other MEMS devices. The numerical solution of the gas damping problem in two-dimensional geometries is obtained based on the Boltzmann-ESBGK equation. The difference in damping force between downward and upward moving beams is shown to vary from as lit...

A fundamentally precise and simple linear motion axis design is discussed where the attractive force from the linear motor is used to preload a carriage supported by six rigidly attached porous carbon air bearings. The air bearings are assembled by vacuuming the pads to two orthogonal planes, positioning the carriage above the pads, and then injecting epoxy between the bearings and the carriage...

An improved theoretical approach is proposed to predict the dynamic behavior of long, slender and flexible microcantilevers affected by squeeze-film damping at low ambient pressures. Our approach extends recent continuum gas damping models (Veijola 2004 J. Micromech. Microeng. 14 1109–18, Gallis and Torczynski 2004 J. Microelectromech. Syst. 13 653–9), which were originally derived for a rigid ...

This paper reports analytical modeling and finite element analysis (FEA) of the effect of two types of air damping (squeeze film and slide film damping) on resonance frequency and quality factor of a multi-layer CMOS-MEMS resonator designed for application as a mass sensitive gas sensor. The sensing principle is based on change in frequency or amplitude of the resonator due to adsorption/absorp...

We propose an engineered reservoir inducing the relaxation of a cavity field towards nonclassical states. It is made up of two-level atoms crossing the cavity one at a time. Each atom-cavity interaction is first dispersive, then resonant, then dispersive again. The reservoir pointer states are those produced by an effective Kerr Hamiltonian acting on a coherent field. We thereby stabilize squee...

The use of femtosecond laser pulses generated by a Ti:Sapphire laser system allows us to gain an insight into the magnetization dynamics on time scales from sub-picosecond up to 1 ns directly in the time domain. This experimental technique is used to excite a polycrystalline nickel (Ni) film optically and probe the dynamics afterwards. Different spin wave modes (the Kittel mode, perpendicular s...

Squeeze film dampers are widely used in aircraft engines, land-based gas turbines, and other rotating machines to improve system damping. They often have entrained air within the oil film, which is usually not taken into account in rotordynamics analysis due to lack of good formulations of the effects involved. The effects on the damping force calculation can be significant. This work presents ...

In this study the dynamic behaviour of perforated microplates oscillating under the effect of squeeze film damping is analyzed. A numerical approach is adopted to predict the effects of damping and stiffness transferred from the surrounding ambient air to oscillating structures; the effect of hole’s cross section and plate’s extension is observed. Results obtained by F.E.M. models are compared ...