Experiments were conducted with PF-5052 liquid sprays impacting a 1.0 1.0 cm heated test surface at different inclination angles, flow rates, and subcoolings. Inclination angle had no noticeable effect on the single-phase or two-phase regions of the boiling curve. Maximum CHF was always achieved with the spray impinging normal to the test surface; increasing angle of inclination away from the n...

We described the fabrication of functional and microstructured surfaces from polymer blends by spray deposition. This simple technique offers the possibility to simultaneously finely tune the microstructure as well as the surface chemical composition. Whereas at lower polymer concentration, randomly distributed surface micropatterns were observed, an increase of the concentration leads to signi...

In this computational research, the separate and simultaneous impacts of diesel direct injection timing, fuel spraying cone angle, and hydrogen gas addition on combustion characteristics, output emissions, and performance in a single-cylinder direct injection diesel engine was studied. In order to conduct the simulations, valid and reliable models for combustion, break-up, and for turbulence wa...

P roper angulation of the airpolisher handpiece and use of high-velocity evacuation significantly minimize the generation and the liberation of the aerosol particles into the dental environment. 1S16 As can been seen in Figures 1 through 3. the handpiece nozzle should be held 3-4 mm from the tooth surface, The handpiece nozzle should be kept at a 60 0 angle toward the facial and lingual surface...

Liquid fuel injection and atomization have a significant influence on the combustion and emission characteristics of diesel engines. Using x-ray radiography, it is possible to obtain quantitative and time-resolved data in the primary breakup region close to the injector nozzle. However, most previous studies on model validations have employed optical measurements that are not applicable in this...

In this paper, a method is presented for lowering the energy consumption and/or increasing the speed of a standard manipulator spray painting a surface. The approach is based on the observation that a small angle between the spray direction and the surface normal does not affect the quality of the paint job. Recent results in set-based kinematic control are utilized to develop a switched contro...

main purpose of current study is development of a new multi zone model for direct injection diesel engines. zone configuration is based on conical shape of spray. siebers’s correlation is used for spray cone angle calculation. experimental data are used for calculation of fuel inlet mass flow rate. fuel diffusion in different zones is calculated using fick’s law. a chemical kinetics mechanism c...

Evaporative cooling by water spray is increasingly used as an efficient and environmentally-friendly approach to enhance thermal comfort in built environments. The complex two-phase flow in a water spray system is influenced by many factors such as continuous phase velocity, temperature and relative humidity patterns, droplet characteristics and continuous phase-droplet and droplet-droplet inte...

The hot water sprays are an important part of many industrial processes, where the detailed knowledge of physical phenomena involved in jet transportation, interaction, secondary breakup, evaporation, and coalescence of droplets is important to reach more efficient processes. The objective of the work was to study the water spray jet breakup dynamics, vortex cloud formation, and droplet size di...