A method for shortening of the settling time in all digital phase-locked loops is proposed. The method utilizes self monitoring to obtain the parameters necessary for feed-forward compensation. Analysis shows that by employing this technique both fast settling and good stability can be achieved simultaneously. Matlab and Verilog-AMS simulation shows that typical settling speed can be reduced to...

PURPOSE To investigate the effect of feed preparation characteristics and operational parameters on mixing homogeneity in a convective batch ribbon mixer. METHODS Lactose 100M, lactose 200M, ascorbic acid, and zinc oxide powders were used for the mixing study. Operational parameters studied were rotational speed and mixing time. The feed preparations studied were the use of preblending and th...

High-speed steel (HSS) tools are the most commonly used tools in small and medium-scale industry. Cryogenic treatment can be used to enhance the tool life. Studies on cryogenically treated (CT) cutting tools show micro structural changes in the material that can influence the life of the tools significantly. This paper primarily reports performance of CT HSS tools as compared to untreated (UT) ...

Nowadays, application of cermet coatings deposited by High-Velocity Oxygen-Fuel (HVOF) has received considerable attention in a variety of industries. Carbide coatings have high surface roughness, so it is essential to grind the coated surface. The present investigation studied the effect of simultaneous changes in the grinding parameters including the depth of cut, feed rate and cutting sp...

Nowadays the surface texturing has been widely recognized as a usable capability to improve the tribological systems. In this paper, ultrasonic assisted turning (UAT) isperformed to create the micro textures on the flat faces. Micro surface texturing ismade on the Al7075-T6 by the UAT in the face turning process. Then, the influences of cutting speed feed, vibration direction and vibration ampl...

In order to realize high speed machining, the special requirements for feed transmission system of machining center have to be satisfied. A high velocity feed unit driven by an induction linear motor has been developed. The architecture of the high velocity CNC feed unit is presented and difficulties encountered in the unit design are discussed.

This paper outlines the fractional factorial approach of D.O.E. techniques (Taguchi & Response Surface Methodology) are applied to optimize turning process parameter in order to obtain better surface finish. The turning parameters evaluated are cutting speed, feed, and depth of cut. An orthogonal array, signal-to-noise (S/N) ratio, and Pareto analysis of variance (ANOVA) are employed to analyze...

Cutting tests were conducted to medium carbon steel using HSS tools with cutting fluid. The experimental design used was based on response surface methodology (RSM) using a central composite design. Chips were collected at different machining conditions and thickness and microhardness measurements taken and analyzed using “DESIGN EXPERT 7” experimental design software. Mathematical models of th...

A mathematical model of the surface roughness has been developed by using response surface methodology (RSM) in grinding of AISI D2 cold work tool steels. Analysis of variance (ANOVA) was used to check the validity of the model. Low and high value for work speed and feed rate are decided from design of experiment. The influences of all machining parameters on surface roughness have been analyze...