نتایج جستجو برای: resistance heating

تعداد نتایج: 428426  

2013
B. Engel

Manufacturing components of fiber-reinforced thermoplastics requires three steps: heating the matrix, forming and consolidation of the composite and terminal cooling the matrix. For the heating process a pre-determined temperature distribution through the layers and the thickness of the pre-consolidated sheets is recommended to enable forming mechanism. Thus, a design for the heating process fo...

Journal: :Journal of colloid and interface science 2011
Bastien Barthélémy Sébastien Devillers Isabelle Minet Joseph Delhalle Zineb Mekhalif

Titanium and its alloys present high interests for technological applications due to their high corrosion resistance, mechanical properties and biocompatibility. In combination with these remarkable characteristics, some Ti applications require specific surface properties that can be imparted with suitable surface functionalizations of the TiO(2) oxide layer. The present work aims to study the ...

Journal: :IEICE Transactions 2010
Toshiki Kanamoto Takaaki Okumura Katsuhiro Furukawa Hiroshi Takafuji Atsushi Kurokawa Koutaro Hachiya Tsuyoshi Sakata Masakazu Tanaka Hidenari Nakashima Hiroo Masuda Takashi Sato Masanori Hashimoto

This paper evaluates impact of self-heating in wire interconnection on signal propagation delay in an upcoming 32 nm process technology, using practical physical parameters. This paper examines a 64-bit data transmission model as one of the most heating cases. Experimental results show that the maximum wire temperature increase due to the selfheating appears in the case where the ratio of inter...

In this paper, the corrosion behavior of the filled epoxy paint with the rice husk ash RHA on steel substrates in two different corrosive environments natural sea water and 2M sulfuric acid has been studied. Electrochemical impedance spectroscopy EIS was used to evaluate protective properties of different organic coating systems due to the different filler composition. RHA was prepared by heati...

Ohmic heating is defined as a process which alternating electric current is passed through food with the primary purpose of heating it due to the electrical resistance and can be specially applied as an alternative heating method. In this research, Aloe vera gel concentrates having 0.5-2% soluble solids were ohmically heated up to 60°C by using four different voltage gradi...

1998
Abelardo Ramirez William Daily

Of the several thermal, mechanical and hydrological measurements being used to monitor the rockmass response in the Single Heater Test, electrical resistance tomography (ERT) is being used to monitor the movement of liquid water with a special interest in the movement of condensate out of the system. Images of resistivity change were calculated using data collected before, during and after the ...

2016
Hailong Dong Ana Kuzmanoski Tobias Wehner Klaus Müller-Buschbaum Claus Feldmann

Eu3+-modified carbon dots (C-dots), 3-5 nm in diameter, were prepared, functionalized, and stabilized via a one-pot polyol synthesis. The role of Eu2+/Eu3+, the influence of O₂ (oxidation) and H₂O (hydrolysis), as well as the impact of the heating procedure (conventional resistance heating and microwave (MW) heating) were explored. With the reducing conditions of the polyol at the elevated temp...

2016
F. Cabannes K. Dembinski

s Some zirconia foams are used as heating elemeht in electrical furnaces. Their creep behaviour has been investigated at high temperature and under low stress. Important visco-elastic behaviour has been observed. It is likely due to recrystallization, which is sensitive to the tetragonal-cubic phase transition and to the stress. I INTRODUCTION Porous and dense zirconia based ceramics have been ...

Journal: :International journal of food microbiology 2003
Pilar Mañas Rafael Pagán Javier Raso Santiago Condón

The influence of the growth temperature and the pH of the heating medium on the heat resistance at different temperatures of Salmonella typhimurium ATCC 13311 was studied and described mathematically. The shift of the growth temperature from 10 to 37 degrees C increased heat resistance of S. typhimurium fourfold. The pH of the heating medium at which heat resistance was maximum was pH 6 for cel...

نمودار تعداد نتایج جستجو در هر سال

با کلیک روی نمودار نتایج را به سال انتشار فیلتر کنید