A rise in CO2 and other greenhouse gases’ concentration from gas refinery flares and furnaces in the atmosphere causes environmental problems. In this work, a new process was designed to use waste gas (flue gas and flare gas) of a domestic gas refinery to produce pure hydrogen in a membrane reactor. In particular, the process foresees that the energy and CO2 content of flue gas can provide the ...

The steady–state operation of the autothermal reformer is simulated as two reactors in series by means of a detailed mathematical model. An input-output model is selected to describe the upper combustion chamber. The possible occurrence of homogeneous steam reforming and watergas-shift (WGS) reactions is considered. The catalyst bed is represented through a one-dimensional heterogeneous model, ...

A large number of theoretical and experimental studies have shown that the performance of kerosene combustion increases significantly if combustion is being assisted by the addition of hydrogen to the fuel/air mixture during the combustion process. It reduces the amount of CO, CO2 and NOx emissions, while increasing the flame stability limits. It also helps in bruning fuel/air mixtures at much ...

in this paper, a hybrid solid oxide fuel cell (sofc) and micro gas turbine (mgt) power system is parametrically studied to evaluate the effect of different operating conditions. the sofc/mgt power system includes sofc reactor, combustion chamber, compressor and turbine units, and two heat exchangers. the effects of fuel utilization, temperature, and pressure are assessed on performance of the h...

Power-to-Liquid (PtL) plants can viably implement carbon capture and utilization technologies in Europe. In addition, local CO2 sources be valorized to substitute oil gas imports. This work’s aim was determine the PtL efficiency obtained by combining a solid oxide electrolyzer (SOEC) Fischer–Tropsch synthesis. recommended plant configuration produce synthetic fuel wax at pilot scale is establis...

The tubes in an Ammonia primary reformer furnace operate close to the limits of materials technology in terms of the stress induced as a result of very high temperatures, combined with large differential pressures across the tube wall. Operation at tube wall temperatures significantly above design can result in a rapid increase in the number of tube failures, since tube life is very sensitive t...

Direct Reduction processes use gases (CO and H2) for iron reduction production of sponge or direct reduced (DRI). The generation this gas occurs through methane reforming, which can be done in a reformer inside the shaft with as catalyst. latter auto-reforming processes. kinetics steam reforming catalyzed by was studied at temperatures between 875°C 1050°C. Results showed that acts catalyst con...

This study evaluates the performance of a molten carbonate fuel cell and micro gas turbine (MCFC/MGT) hybrid power system bi-fueled by city gas and biogas. The performance of the MCFC/MGT hybrid power system and MFCF/MGT hybrid power system response have been investigated experimentally and numerically. Results show that the MCFC, steam reformer, and catalytic combustor models are in agreement ...

Abstract. In PEM fuel cells pure hydrogen is used as a fuel. Due to its low density, the density of its stored energy is low, too. One of the possible solutions to the problem is production of hydrogen from the energy-reach material, e.g. methanol. Conversion of methanol to hydrogen is made with reformer in a steam reforming process in which besides methanol there is also water needed. On the o...

Problem statement: This study describes the use of Reformer Gas (RG) to alter NOx emission in a CNG-fueled HCCI engine. Comparison with diesel, natural gas has a very high octane number (≈120) and high auto-ignition temperature (≈600°C). Composed mostly of methane, natural gas is the only common fuel to manifest relatively pure, single-stage combustion. Other fuels have stronger low-temperature...