This article provides a classification of high efficiency switching power-gyrator structures and their use as cells for energy processing in photovoltaic solar facilities. Having into account the properties of these topologies presented in the article, their inclusion in solar facilities allows increasing the performance of the whole installation. Thus, the design, simulation and implementation...

In this paper a hybrid active DC line conditioner for fluctuations and ripples reduction in voltage and current of DC power systems is proposed. Malfunctions in operation of equipments and systems which are supplied by low quality distribution power systems are one of the main effects of DC voltage ripple. In the proposed configuration a hybrid system including series and shunt active line ...

In this article our objective is to obtain steady state characteristics of shunt, series, and separately excited DC motors coupled with a centrifugal water pump supplied through a step-up, step-down, and cuk converter from photovoltaic generator. We assume that there are no storage batteries and, of course, the system must operate on maximum utilization i.e. maximum water must be pumped. It is ...

Increasing DC loads along with DC nature of distributed energy resources (DERs) raises interest to DC microgrids. Conventional droop/non-droop power-sharing in microgrids suffers from load dependent voltage deviation, slow transient response, and requires the parameters of the loads, system and DERs connection status. In this paper, a new nonlinear decentralized back-stepping control strategy f...

The generation of offshore wind power is less predictable. This can cause the overload of offshore DC transmission system and thus requires the curtailment of wind power. To reduce the amount of wind power curtailment, a method of optimising DC power flow using DC power flow controller (DC-PFC) is proposed. The analytical expression of coordinating DC-PFCs and converters in controlling the powe...

In this paper, we present a modeling and implementation of new control schemes for an isolated photovoltaic (PV) using a fuzzy logic controller (FLC). The PV system is connected to a load through a DC-DC boost converter. The FLC controller provides the appropriate duty cycle (D) to the DC-DC converter for the PV system to generate maximum power. Using FLC controller block in MATLABTM/Simulink e...

‎ In this paper, the stand-alone photovoltaic system for cathodic protection of underground pipelines is presented. The proposed system offers continuous and automatic adjustment of the applied voltage so that the buried pipelines receive the exact current. A modified perturb and observe (P&O) algorithm for maximum power point tracking (MPPT) is used to improve dynamic and steady state performa...

This paper covers the comparison between four different DC-DC converters for solar power conversion. The are buck converter, buck-boost boost and noninverting converter. An MPPT algorithm is designed to calculate battery voltage, current of PV array, voltage output power. It observed that non-inverting converter finest final circuit design has results 12.2V 0.31A 34V 23mW panel, 21.8mW efficien...

this paper presents a detailed small-signal and transient analysis of a full bridge pwm dc-dc converter designed for high voltage, high power applications using an average model. the derived model is implemented in a typical system and used to produce the small-signal and transient characteristics of the converter. results obtained in the analysis of the high voltage and high power design examp...