In Electrochemical Mechanical Planarization process (ECMP), concentrated phosphoric acid is usually used as electrolyte. Role of sodium dodecyl sulfate (SDS) in anodic dissolution of Cu in concentrated phosphoric acid was studied by Cyclic Voltammetry (CV), inhibition efficiency (IE) calculation and in-situ observation of the Cu electrode surface at anodic overpotentials. It was found that pres...

Stainless steels have good corrosion resistance in many environments but welding or aging can decrease their resistance. This work focused on the effect of aging time and ultrasonic nano-crystal surface modification on the passivation behavior of 316L stainless steel. In the case of slightly sensitized 316L stainless steel, increasing the aging time drastically decreased the pitting potential, ...

the effect of chloride ions concentration on the electrochemical behavior of aisi 410 stainless steel in thesimulated concrete pore (0.1 m naoh + 0.1 m koh) solution was investigated by various electrochemicalmethods such as potentiodynamic polarization, mott–schottky analysis and electrochemical impedancespectroscopy (eis). potentiodynamic polarization curves revealed that increasing chloride ...

In this study the effect of crystallite size reduction and microstructure on the electrochemical corrosion behavior of nanocrystalline nickel (NC Ni) were investigated using Tafel polarization and electrochemical impedance spectroscopy (EIS) measurements in 10 wt.% NaOH. NC Ni coatings were produced by direct current electrodeposition using chloride baths in presence and absence of saccharin as...

chromate conversion coating is applied on aluminum 6061. the optimum conditions for chromate bath composition and immersion time are also obtained for standard requirements provision such as corrosion resistance in salt spray test, electrical resistance and coating quality. the applied coatings are electrochemically tested in sea and distilled water. according to tafel and cyclic polarization c...

The effect of chloride ions concentration on the electrochemical behavior of AISI 410 stainless steel in the simulated concrete pore (0.1 M NaOH + 0.1 M KOH) solution was investigated by various electrochemical methods such as Potentiodynamic polarization, Mott–Schottky analysis and electrochemical impedance spectroscopy (EIS). Potentiodynamic polarization curves revealed that increasing chlori...

When a piezoelectric film is glued on the surface of a structure member subjected to mechanical load, a distribution of electric potential is induced. In the existence of defects in the member, a characteristic variation of electric potential is observed. Based on this phenomenon, the passive electric potential CT (computed tomography) method is developed for detecting and identifying defects i...

The electrochemical behavior of passive Fe and thin, sputter-deposited films of Fe2O3 was studied in borate and phosphate buffer pH 8.4 solutions. Cyclic voltammograms and in situ light absorption measurements which enable the monitoring of the oxide film thickness indicate a similar behavior of the Fe electrode in both pH 8.4 solution, especially a presence of a oxide-free surface at low catho...