Abstract: Two different coating microstructures of Ni-50Cr alloy were obtained on a stainless steel substrate by changing combustion characteristics of a high velocity oxy-fuel (HVOF) process and the size distribution of feed powder during coating process. Use of the finer feed powder and leaner fuel in oxygen/fuel ratio (i.e. using a ratio much less than stoichiometric ratio) led to formati...

AbstractSputtered MoS2 coatings have been mostly used as a solid lubricant. In this investigation, MoSx/Ni composite coatings with Ni contents varying from 0 to 22 % were deposited onto steel substrate using a DC magnetron sputter process. The MoS2/Ni ratio in the coatings was controlled by sputtering the composite targets. The composition, microstructure, and mechanical properties of the...

High energetic aluminum nanoparticles are mainly used as additive in solid rocket propellants. However, fabrication of these aluminized energetic materials is associated with decreasing the burning rate of propellants due to problems such as oxidation and agglomeration of nanoparticles. In this study, to improve combustion performance of aluminum nanoparticles, coating by metallic Ni shell...

in this research, tribological behavior of ti-ni-p intermetallic coatings on titanium substrates have been investigated under dry reciprocating conditions. hardness profile testing results exhibit that high surface hardness has been attained and static indentation result shows that the intermetallic coating has better adhesion strength than the conventional ceramic coatings. in this respect, th...

Ni-W coatings, compared to pure nanocrystalline Ni, exhibit higher hardness and wear resistance. In some cases, these coatings are considered as environmental friendly alternatives for hard chromium coating. Till now, most of Ni-W coatings have been produced by direct current electrodeposition from alkaline baths. In this study square pulse current was used for deposition of Ni-W precipitates f...

composite electrodeposition is a low-cost and low-temperature method, which is used to make metal matrix composite coatings. in this study the surfactant of anionic(sds) and cationic (ctab) is used as additive in composite coating of ni/tin. the results showed that the anionic surfactant caused more particles in the composite coatings. increasing sds concentration to the optimal value leads to ...

A commercial plasma enhanced chemical vapor deposition (PECVD) technique with planetary substrate rotation was used to apply a thin (200-400 nm thick) conformal diamond-like carbon (DLC) coating (known as a diamond-like nanocomposite (DLN)) on LIGA fabricated Ni-Mn alloy parts. The PECVD technique is known to overcome the drawbacks associated with the line-of-sight nature of physical vapor depo...

Functional plating such as alloys or dispersion coatings have been widely used in metal finishing industry. In general, dispersion coatings are deposited from plating baths containing suspended particles such as metal oxides, carbides, metals or organic materials,(l-3) Codeposited particles in the dispersion coatings have the remarkable influence on the properties of the deposits depending on t...

By restricting the dilated deformation, surface modification can stimulate multiple shear banding and improve the plasticity of bulk metallic glasses (BMGs). Aimed at modifying the surface of BMGs by thin layers, a crystalline Ni coating with ultrafine grains was coated on the surface of a Ti-based BMG by electroless plating. With a thickness of about 10 μm, the prepared thin coating could effe...