.................................................................................................... 9 Chapter 1: Introduction ........................................................................ 10 1.1 The waste tire ............................................................................. 10 1.2 Methods for recycling waste tires ............................................. 13 1.2.1 L...

Carbon materials are, in general, very good absorbents of microwaves, i.e., they are easily heated by microwave radiation. This characteristic allows them to be transformed by microwave heating, giving rise to new carbons with tailored properties, to be used as microwave receptors, in order to heat other materials indirectly, or to act as a catalyst and microwave receptor in different heterogen...

Dyeing of polyester fabrics with thienobenzochromene disperse dyes under conventional and microwave heating conditions was studied in order to determine whether microwave heating could be used to enhance the dyeability of polyester fabrics. Fastness properties of the dyed samples were measured. All samples dyed with or without microwave heating displayed excellent washing and perspiration fastn...

Biomass was subjected to conventional and microwave pyrolysis, to determine the influence of each process on the yield and composition of the derived gas, oil and char products. The influence of pyrolysis temperature and heating rate for the conventional pyrolysis and the microwave power was investigated. Two major stages of gas release were observed during biomass pyrolysis, the first being CO...

The oxidation stability of extra virgin and refined olive oils produced in different countries were studied under different conditions of microwave heating (microwave oven Electrolux, 2450 MHz, 500 W) and conventional heating (200°C). Oils were heated in a microwave oven and in a conventional oven for 0, 3, 6, 9, 12, 15, 20, 25, and 30 minutes. The evaluated parameters were peroxide value, cont...

This paper focused on a simple approach for synthesis of molybdenum oxide (MoO3) nanoparticles and reports a facile route for synthesis of such nanoparticles, using microwave irradiation as a homogenous and powerful source of heating, using ethylene glycol as the solvent and heating medium. For more investigations, besides microwave heating, the obtained solutions were also treated by conventio...

When traditional sintering techniques are used it is difficult to obtain dense materials with nanometric or submicrometric grain sizes. Microwave sintering was proposed as an alternative technique to overcome the problems of conventional fast heating. However, various problems usually occur when ceramics are sintered by direct microwave heating [1]. Hybrid heating techniques, which combine dire...

A brightness of 76% (initially 57%) was reached with a charge of 4.5% hydrogen peroxide based on thermomechanical pulp in 10 min with microwave heating, compared to 45 min with water-bath heating. The maximum brightness attained with water-bath heating (78%) was nearly one point higher than that obtained with microwave heating, albeit after twice the time (120 min vs. 60 min). Under similar con...

Introduction: NASA is evaluating various methods to process lunar and Mars regolith in preparation for future missions. We have performed earlier studies [1-3] to understand the mechanism associated with the lunar regolith’s excellent absorbtion of microwave energy that is useful for microwave processing. Using an upgraded microwave heating facility we have shown that the previously observed [4...

Suspensions of Escherichia coli and Bacillus subtilis spores were exposed to conventional thermal and microwave energy at 2,450 MHz. The degrees of inactivation by the different energy sources were compared quantitatively. During the transient heating period by microwave energy, approximately a 6 log cycle reduction in viability was encountered for E. coli. This reduction was nearly identical t...