Due to its particular configuration, the Consequent Pole Permanent Magnet (CPPM) machine allows one to easily control the airgap flux in a wide range so that the power capability of the machine is increased over a wide speed range. Two components of the flux, one almost constantcoming from the permanent magnet located on the rotor surface of the machine, and the other –variablecoming from a fie...

In this paper, a new method is proposed for the speed control of a three-phase current forced synchronous machine drive. This metohd is based on the use of an approximate constant commutation safety margin angle in the output thyristor bridge of the drive system as well as on the compenastion of stator magnetization reaction. The commutation process in the output converter of the machine driv...

power system overvoltages due to switching, lightning and other disturbances are the main problem for designers of the power transformers. once some frequencies of the incoming surges match with some of the natural frequencies of transformer winding, the resonance phenomenon is expected in transformer winding. the resonant overvoltages may destroy the insulation between turns and cause to insul...

Cable wound electric machines are used mainly for high voltage and direct-drive applications. They can be found in areas such as wind power, hydropower, wave power and high-voltage motors. Compared to conventional winding techniques, cable winding includes fewer manufacturing steps and is therefore likely to be better suited for automated production. Automation of the cable winding production s...

In this paper, a generalized formula is proposed for the selection of number of slots required for n-phase alternative current (AC) machine design and the criterion for selecting the starting points of each phases. The analytical model is verified using a four-pole machine with a 36-slot stator. Each coil of the stator winding of this machine is brought out to a patch board that enables the sta...

An electric commutated frog-leg winding permanent-magnet (PM) DC machine is proposed in this paper. It has a semi-closed slotted stator with a classical type of mesh winding introduced from the conventional brushed DC machine and a polyphase electric commutation besides a PM excitation rotor and a circular arrayed Hall position sensor. Under the cooperation between the position sensor and the e...

This paper presents a design methodology dedicated to multiphase Permanent Magnet Synchronous Machines (PMSM) supplied by Pulse Width Modulation Voltage Source Inverters (PWM VSI). Firstly opportunities for increasing torque density using the harmonics are considered. The specific constraints due to the PWM supply of multiphase machines are also taken into account during the design phase. All t...

Winding is an integral operation in almost every roll to roll system. A center-wound roll is one of the suitable and general schemes in a winding mechanism. In general, the quality of wound roll is known to be related to the lateral displacement error and starring defect of a wound roll. Especially, a telescoping within a center-wound roll can cause damages such as misalignment between layers, ...