generally, fatigue failure in an element happens at the notch on a surface where the stress level rises because of the stress concentration effect. the present paper investigates the effect of a notch on the fatigue life of the hsla100 (­high strength low alloy) steel which is widely applicable in the marine industry. tensile test was conducted on specimens and mechanical properties were obtain...

It is difficult to conduct cyclic tensile fatigue tests for fine ceramics because of its high brittleness, and a little eccentricity of loading axis and gripping device gives inaccurate strength data. So, a major part of cyclic fatigue tests have been carried out under bending load conditions, for the allowance of misalignment of loading axis is generous to some extent in the case of bending fa...

We carried out an elastic and plastic analysis successfully against a new type beryllium window for the SPring-8 front ends. The new window has beryllium foils of high-purity and fine-surfaceroughness on user’s demand. It was confirmed that the new foil has only about half the mechanical strength of the existing one by a static tensile test. Based on the analysis solutions and the tensile test ...

Introduction Fibrillation of cartilage has been attributed to failure of the collagen network in its superficial layer [1]. Fatigue of the collagen fibrils, which can only carry tensile stresses, is thus seen as a contributor to the collagen network failure. Previous work on cartilage resistance to fatigue has been undertaken on specimens, which were loaded in the direction of the collagen in t...

this experimental study investigated the effects of quenching and tempering heat treatment on fatiguebehavior and also tempering temperature and time holding of aisi 1060 steel. at first, the specimenswere austenitized at 800˚c for 1 hour, and then were quenched in the water bath of 25˚c temperature.after that, tempering process was done at the temperature of 250˚c, 450˚c and 650˚c for 1 and 2 ...

silica refractory bricks are used especially in the metallurgical industries, due to desirable properties suchas high melting point, rigidity, and high temperatures strength. in this research, different amount of sicwere added to silica refractory containing different binders such as borax, boric acid, calcium nitride,sodium tri poly phosphate, sodium hexa meta phosphate (shmp) and lime. physic...

Under badly environmental conditions as well as complex loads, corrosion of embedded reinforcing steel bars in concrete is common for reinforced concrete (RC) structures. Fatigue of corrosion reinforcing steel bars is a key problem for old RC bridges. To assess the residual fatigue life of aged existing RC bridges, the most new study information on fatigue of natural corrosion reinforcement is ...

The fatigue strength of flapper valves depends among other things on surface properties of the steel. This paper deals with the effect of a tumbling method*) on bending and tensile fatigue properties of test bars. For carbon steel SANDVIK 20C an improvement was observed in several test series, particularly in the transverse direction of the strip, whereas there was little effect for stainless s...

This paper investigates the effect of loading level and loading rate on the damage development and strength on the asphalt mixtures tested at three low temperatures. The current AASHTO specification for asphalt mixture low-temperature characterization consists of two tests: the indirect tensile creep (ITC) test and the indirect tensile strength (ITS). In the ITC, the load was applied until the ...