tube hydroforming (thf) process is used to produce the complex components from the initial cylindrical tubes. in this paper, t- shape component was formed using a tube hydroforming machine and the residual stresses of hydroformed tube was determined by hole drilling method. subsequently, the thickness distribution and residual stresses of final tube were investigated using experimental and fini...

We present a drilling method that is based on the phenomenon of local hot spot generation by near-field microwave radiation. The microwave drill is implemented by a coaxial near-field radiator fed by a conventional microwave source. The near-field radiator induces the microwave energy into a small volume in the drilled material under its surface, and a hot spot evolves in a rapid thermal-runawa...

[1] Integrated Ocean Drilling Program (IODP) Hole 1301A was drilled, cased, and instrumented with a long‐term, subseafloor observatory (CORK) on the eastern flank of the Juan de Fuca Ridge in summer 2004. This borehole is located 1 km south of ODP Hole 1026B and 5 km north of Baby Bare outcrop. Hole 1301A penetrates 262 m of sediment and 108 m of the uppermost 3.5 Ma basaltic basement in an are...

How to effectively transfer and exert a pressure on drills in lateral drilling, and to raise the efficiency of rock-breaking and rate of penetration in a bid, is the key technology to improve the quality, speed and economic benefits of lateral drilling. Therefore, based on high pressure jet of 16-hole and 7-hole nozzles, which are suitable for lateral drilling in oilfield at the present stage, ...

Drilling is one of the important machining processes in hole making operations. Delamination is a vital problem during any drilling operation. It causes structural integrity reduction and poor assembly tolerance as well as potential for long-term performance deterioration. As a result, drilling of any material requires dimensional stability and interface quality. In this study, glass fibre rein...

Micro drilled holes are utilized in many of today's fabrication processes.Precision production processes in industries are trending toward the use of smaller holeswith higher aspect ratios, and higher speed operation for micro deep hole drilling. However,undesirable characteristics related to micro drilling such as small signal-to-noise ratios,wandering drill motion, high aspect ratio, and exce...

Here we present a method for high-precision drilling using an industrial robot with high-bandwidth force feedback, which is used for building up pressure to clamp-up an end-effector to the work-piece surface prior to drilling. The focus is to eliminate the sliding movement (skating) of the end-effector during the clamp-up of the end-effector to the work-piece surface, an undesired effect that i...

In this paper, micro-hole drilling in ambient air is presented using fs fiber laser (750 fs & 1030 nm). Micro holes were fabricated in both transparent (glasses) and non-transparent materials (metals and tissues). Hole shape and morphology was characterized and evaluated with optical microscope and scanning electron microscopy (SEM). Debris-free micro holes with good roundness and no thermal da...

Hole drilling is the most widespread method for measuring residual stress. It is based on the principle that drilling a hole in the material causes a local stress relaxation; the initial residual stress can be calculated by measuring strain in correspondence with each drill depth. Recently optical techniques were introduced to measure strain; in this case, the accuracy of the final results depe...