نتایج جستجو برای: height of transfer unit
تعداد نتایج: 21216925 فیلتر نتایج به سال:
in order to simulate the rotating disk contactor all hydrodynamic parameters, dispersed phase hold-up, characteristic velocity, mean drop size, drop size distribution, axial mixing and mass transfer have been taken into account. mechanisms of mass transfer (stagnant, circulating, oscillating drops) were used in this study. column height found from effect of mean drop size and drop size distribu...
the purpose of this two-phase, sequential mixed methods study was to find out whether there were any decencies between male and female ma students’ theses regarding the common features of academic writing such as syntactic complexity, means of integrating cited information, and organizing arguments. i chose 10 male written theses and 15 female written theses in tefl and linguistics. in the firs...
objective: the objective of this study was to investigate the invitro fluoride release of four new self-adhesive resin cements; set (sdi, australia), breeze (pentron, usa), embrace wetbond (pulpdent, usa), g-cem (gc, japan) and to assess the bonding performance of these self-adhesive resin cements for bonding of orthodontic brackets. materials and methods: for fluoride release experiment, six ...
a thermodynamic analysis of the counter flow wet cooling tower (cwct) in the steelmaking unit of the khuzestan steel company (ksc) is performed in this paper. we evaluated both energy and exergy formulations for analyzing the heat and mass transfer, exergy and second-law efficiency in this cooling tower. the lewis factor le f is an indication of the relative rates of heat and mass transfer in a...
In this paper a numerical investigation is performed to study the effects of different nanofluids on convective heat transfer enhancement in a partitioned square cavity subject to different shapes of nanoparticle using water-SiO2 nanofluid. This study has been carried out to analyze the effects of SiO2 nanoparticle, its volumetric fraction between 2 and 4%, and nanoparticle shape (i.e. blades, ...
Objective: Drying is one of the most important post-harvesting processes in agriculture. Drying method and also drying time have an important effect on the amount of energy required. In this study analysis of energy consumption for drying corn in dryer reservoir with flow of warm air and the effect of the temperature and height of product layer on the amount of energy consumption per unit mass ...
A measurement device for sieve plates have been designed and built at Helsinki University of Technology. The unit consists of a rectangular transparent container where one plate is installed. The flow path on the plate is of constant width. The plate is easy to change and sieve plates with two different diameters of holes have already been measured. The measurements have been done with two syst...
This study was conducted in oak forests of Ilam province in order to evaluate the morphological characteristics of old trees including diameter at breast height, trunk height, whole tree height, minimum and maximum crown diameter, crown health, crown vitality, crown symmetry, health and form of the trunk, Was investigated. Selection of old trees was performed based on the criteria of DBH and wi...
Using of nanofluids and ducts with corrugated walls are both supposed to enhance heat transfer, by increasing the heat transfer fluid conductivity and the heat transfer area respectively. Use of a diverging duct with a jet at inlet section may further increase heat transfer by creating recirculation zones inside the duct. In this work two-dimensional incompressible laminar flow of a nanofluid e...
نمودار تعداد نتایج جستجو در هر سال
با کلیک روی نمودار نتایج را به سال انتشار فیلتر کنید