نتایج جستجو برای: heating and cooling cycle
تعداد نتایج: 16879412 فیلتر نتایج به سال:
run-out-table (rot) is located between last finishing stand and down coiler in a hot strip mill. as the hot steel strip passes from rot, water jets impact on it from top and bottom and strip temperature decreases approximately from 800-950 °c to 500-750°c. the temperature history that strip experience while passing through rot affects significantly the metallurgical and mechanical properties, s...
In this study, the performance of an adsorbent coated finned tube exchanger for carbon capture was investigated numerically. The results showed that this structure has a great potential for being applied as a medium for CO2 capture by rapid indirect thermal swing adsorption. By using this structure, the recovery of 96%, and purity of 98% were achieved with a simple cycle consisting of two steps...
The oxidation state of palladium in a model Pd/ ACZ three-way catalyst was monitored by synchronous XANES and mass spectrometry during two consecutive heating (to 850 C) and cooling (to 100 C) cycles under stoichiometric conditions simulating exhaust after treatment of a natural gas engine. During heating in the first cycle, PdO reduction occurred around 500 C and the initial fully oxidized sta...
this paper describes a study that starts with an analysis of typical energy demand profiles in a hospital setting followed by a case study of a combined cooling, heating, and power (cchp) generation system.cchp is an autonomous system that combines the generation of electrical, heating, and cooling energy.the driving units are two high-efficiency gas engines that produce electrical and heat ene...
We examine recent developments in the cluster cooling flow scenario following recent observations by Chandra and XMM-Newton. We show that the distribution of gas emissivity verses temperature determined by XMM-Newton gratings observations demonstrates that the central gas, i.e., where the cooling time is less than the age of the cluster, in cooling flow clusters cannot be in simple steady-state...
The feasibility of using carbon foam as a heat sink and heat spreader in optoelectronic packages is assessed. A “supercooler” is designed, fabricated and tested to verify its cooling capability under high heat flux conditions in a typical optoelectronic package. The supercooler uses carbon foam as a primary heat transfer material. Water is soaked into the carbon foam and under evacuated pressur...
Recently Debates about Energy and the issue of global warming have led to the use of new energy. One of the best options for this purpose is the use of a new hybrid system of power, heating and refrigeration, with its thermal source of solar and geothermal energy. In the present study, used a combined cooling, heating and power system based on the organic Rankine cycle and the Ejector Refrigera...
Data collected at the Atmospheric Radiation Measurement (ARM) Program ground sites allow for the description of the atmospheric thermodynamic state, cloud occurrence, and cloud properties. This information allows for the derivation of estimates of the effects of clouds on the radiation budget of the surface and atmosphere. Herein 8 yr of continuous data collected at the ARM Southern Great Plain...
نمودار تعداد نتایج جستجو در هر سال
با کلیک روی نمودار نتایج را به سال انتشار فیلتر کنید