accumulative roll bonding (arb) was used to fabricate the cu-zn multilayer and cu-zn solid solution. a lamellar structure with the hardness of about 130 vhn was formed after eight arb cycles. following to the suitable heat treatment, a solid solution with a uniform microstructure and hardness of about 57 vhn was produced. the dominant wear mechanism in the arb processed multilayer was found to ...

This paper presents frictional characteristics of thrust bearing in scroll compressor. The coefficient of friction in thrust bearing was measured by both elemental friction test and loss classification based on the performance test of actual scroll compressor, and investigated frictional characteristics focusing on the behavior of sliding portion which affects the generation of oil film by expe...

braced frames structures have a good lateral stiffness against earthquakes. however, energy loss of their members is slight and strong forces are given to the structures. moment frames have a more flexible function against earthquakes and also have a better flexibility than braced frames. however, since its lateral stiffness is low, too much displacement of the structure results in an increase ...

  Micro scale gas flows has attracted significant research interest in the last two decades. In this research, the fluid flow of gases in the stepped micro-channel at a wide range of Knudsen number has been analyzed with using the Lattice Boltzmann (MRT) method. In the model, a modified second-order slip boundary condition and a Bosanquet-type effective viscosity are used to consider the veloci...

coeffcient of  friction  (cof)  for  rubber parts  is one of  the key parameters in their interaction with solid rough surfaces (micrometer to millimeter scales),  such  as  tire-road  interactions. cof  of  rubber  depends  on  viscoelastic properties of rubber, roughness characteristics of the counter-part surface, and process variables such as contact nominal pressure and sliding speed. due ...

recent developments in nanostructured products draw considerable attention to ultrafine grained materials. these materials are normally manufactured by different severe plastic deformation (spd) methods. in the present study, analytical models and finite element method (fem) are used to calculate strain imposed to a specimen that was deformed by equal channel angular pressing (ecap). in additio...

Load-dependent power loss is a major contributor to power loss in gear transmission systems. In this study, pin-on-disc frictional and FZG efficiency experiments were conducted with powder metallurgy (Distaloy AQ ? 0.2 %C) and wrought material (16MnCr5) combinations. The gear mesh torque loss from gear efficiency tests and the friction coefficient from the pin-on-disc tests were then compared. ...