The accurate control of the wellbore pressure not only prevents lost circulation/blowout and fracturing formation by managing the density of the drilling fluid, but also improves productivity by mitigating reservoir damage. Calculating the geothermal pressure of a geothermal well by constant parameters would easily bring big errors, as the changes of physical, rheological and thermal properties...

In oil and gas and geothermal installations, open channels followed by sieves for removal of drill cuttings, are used to monitor the quality and quantity of the drilling fluids. Drilling fluid flow rate is difficult to measure due to the varying flow conditions (e.g., wavy, turbulent and irregular) and the presence of drilling cuttings and gas bubbles. Inclusion of a Venturi section in the open...

Oil-based drilling fluid is used more and more in the field of oil and gas exploration. However, because of unrecyclable treating agent and hard treatment conditions, the traditional treating technologies of waste oil-based drilling fluid have some defects, such as waste of resource, bulky equipment, complex treatment processes, and low oil recovery rate. In this work, switchable deoiling agent...

The past decade has seen increased focus on nanoparticle (NP) based drilling fluid to promote wellbore stability in shales. With the plugging of NP into shale pores, the fluid pressure transmission can be retarded and wellbore stability can be improved. For better understanding of the interaction between shale and NP based drilling fluid based on previous pressure transmission tests (PTTs) on A...

Multiplicity of the effective factors in drilling reflects the complexity of the interaction between rock mass and drilling bit, which is followed by the dependence of parameters and non-linear relationships between them. Rock mass or, in other words, the formation intended for drilling, as the drilling environment, plays a very essential role in the drilling speed, depreciation of drilling bit...

optimization of drilling fluid parameters such as mud weight, salt concentration, and temperature is essential to alleviate instability problems during drilling through shale sections. the selection of suitable mud parameters can benefit from analyses that consider significant instability processes involved in shale-drilling–fluid interactions. this paper describes the development of analytical...

Starch is one of the most widely used biopolymers in water based drilling fluids to control fluid loss. The thermal stability of starch in common drilling fluids is low (93 °C). In this study, the thermal stability of starch has been evaluated in sodium/potassium formate and potassium chloride fluids. Samples of mud were prepared by formate salts (sodium and potassium) and potassium chloride wi...

Wellbore instability in oil and gas drilling is resulted from both mechanical and chemical factors. Hydration is produced in shale formation owing to the influence of the chemical property of drilling fluid. A new experimental method to measure diffusion coefficient of shale hydration is given, and the calculation method of experimental results is introduced. The diffusion coefficient of shale ...

Perforation in internal upset transition zone is one of the main failure styles for drill pipes. Due to the flow channel specificity of upset transition zone, in this paper, drill pipe failure analysis from the point of flow erosion was put forward. Flow field of drilling fluid in the internal upset transition zone of U127 mm API IEU S135 drill pipe under various conditions were obtained using ...

There has been an increasing interest in seafloor exploitation such as mineral mining in deep-sea hydrothermal fields, but the environmental impact of anthropogenic disturbance to the seafloor is poorly known. In this study, the effect of such anthropogenic disturbance by scientific drilling operations (IODP Expedition 331) on seabed landscape and megafaunal habitation was surveyed for over 3 y...