this study was carried out to determine some mechanical properties of barley seed including deformation, rapture force, rapture energy and toughness as a function of moisture content (10.5%, 12.5%, 14.5% , 16.5%, db), loading rate (5, 15, 25, 35 mm.min-1) and grain size (small, medium, large). tests were performed at 7 replications by the means of a factorial base plot experiment. the results s...

deformation length is one of the most important parameters in cold roll-forming process, which plays a fundamental role in determining the inter-distance between the stations and rate of deformation. deformation length was first introduced by bhattacharyya. he also obtained a closed-form relation for this length in roll-forming of symmetric channel section. in this paper, deformation length in ...

the built up layer thickness in secondary deformation zone is one of the important parameters in metal cutting process. the built up layer (bul) is formed in second deformation zone near the tool-chip interface in the back of the chip. this parameter influences the tool life and machined surface quality. this bul should not be confused with the built up edge (bue). the deformation of the bul in...

It is well-known that severe deformation to metals causes a direct grain refinement of the matrix without special heat-treatments due to the mechanism of dynamic continuous recrystallization (DCR). However, the microstructural revolution during severe deformation is seemed to be different depending on the deformation mode, namely the direction of deformation. In general, multi-directional defor...

rndetermination of rock mass deformation modulus is very important in different projects, especially in civil and mining engineering works. in-situ measurements such as dilatometer, plate load and flat jack methods may be applied to determine the deformation modulus. however, these methods are very expensive and time- consuming. analytical methods are very useful approaches which can also be us...

superplastic materials show a very high ductility. this is due to both peculiar process conditions and material intrinsic characteristics. however, a number of superplastic materials are subjected to cavitation during superplastic deformation. evidently, extensive cavitation imposes significant limitations on their commercial application. the deformation and failure of superplastic sheet metals...

this study was conducted in order to investigate the influence of plastic deformation on the transformation of retained austenite in a trip steel with a high content of al and a low content of si. to the aim, appropriate treatments were used to produce the starting material (trip steel). the microstructure of the obtained steel was composed of bainite and phases including ferrite and retained a...