Based on analytical and experimental test methods, an evaluation of coated tools efficiency in milling Ti6Al4V with coated cemented carbide inserts is introduced. The stress-strain curves and the fatigue critical loads of the investigated coating were determined at various temperatures by nanoindentations and impact tests respectively, employing FEM-supported algorithms for results evaluation. ...

If we can evaluate a curve by means of a corner cutting algorithm, we call the corresponding system of functions a corner cutting system. We prove that corner cutting systems are always monotonicity preserving. We obtain weak sufficient conditions for corner cutting systems. Optimal stability properties and properties concerning the supports of the basis functions of corner cutting systems are ...

In this study, a methodology has been developed with the objective of evaluating the surface roughness obtained during turning processes by measuring the signals detected by a force sensor under the same cutting conditions. In this way, the surface quality achieved along the process is correlated to several parameters of the cutting forces (thrust forces, feed forces and cutting forces), so the...

Manufacturing processes are responsible for climate change due to the emissions produced as result of energy consumption. This paper analyzes the influence of the cutting conditions and the characteristics of cutting tools on the energy required in machining processes and the carbon dioxide equivalent (CO2-eq) emissions generated per material removed ratio (MRR) in an effort to define common cr...

The effects of cutting tool coating material and cutting speed on cutting forces and surface roughness were investigated by Taguchi experimental design. Main cutting force, Fz is considered as a criterion. The effects of machining parameters were investigated using Taguchi L18 orthogonal array. Optimal cutting conditions were determined using the signal-to-noise (S/N) ratio which is calculated ...

The use of cutting fluid in manufacturing industries has now become more problematic due to environmental pollution and health related problems of employees. Also the minimization of cutting fluid leads to the saving of lubricant cost and cleaning time of machine, tool and work-piece. The concept of minimum Quantity Lubrication (MQL) has come in to practice since a decade ago in order to overco...

An interior point cutting plane algorithm for solving Maximum Cut problems of a particular structure is described. The problem of interest is determining the ground states of two dimensional J Ising spin glasses on square lattices with nearest neighbour interactions and periodic boundary conditions. Computational results for grids of sizes up to 100 100 are presented. An estimate of the ground ...

The development of chip morphology, critical cutting conditions of serrated chip formation and cutting forces were observed and measured by high speed machining experiment for 30CrNi3MoV hardened steel. Results show that the cutting speed and rake angle are leading factors to influence chip morphology and cutting forces. With the increase of cutting speed, the continuous band chip transforms in...

The paper presents the results of experimental work on assessment 3D geometry surface stereometry obtained as a result Water Jet (AWJ) water-abrasive beam cutting using an Eckert Opal WaterJet COMBO hydro-abrasive cutter. Studies geometric structures were conducted Alicona Infinite Focus microscope. article analyses selected spatial roughness parameters multilayer structure surfaces combined vu...