In this paper, an Adaptive Neuro Fuzzy Inference System (ANFIS) based control is proposed for the tracking of a Micro-Electro Mechanical Systems (MEMS) gyroscope sensor. The ANFIS is used to train parameters of the controller for tracking a desired trajectory. Numerical simulations for a MEMS gyroscope are looked into to check the effectiveness of the ANFIS control scheme. It proves that the sy...

Gyroscopes are instruments capable of sensing changes in their inertial orientation. A gyroscope has one or more sensitive axis and can measure a rotation around them. They are usually mechanical devices that employ a rapid spinning mass to detect the inertial variations. Satellites usually have gyroscopes in the Attitude and Orbit Control System as attitude (orientation) sensors that measure a...

in this paper, an adaptive neuro fuzzy inference system (anfis) based control is proposed for the tracking of a micro-electro mechanical systems (mems) gyroscope sensor. the anfis is used to train parameters of the controller for tracking a desired trajectory. numerical simulations for a mems gyroscope are looked into to check the effectiveness of the anfis control scheme. it proves that the sy...

This paper presents results from the experimental evaluation of a state-of-the-art fiber-optics gyroscope. The purpose of our experiments was to evaluate the suitability of this gyroscope for enhancing dead-reckoning in mobile robots. The evaluated gyroscope was the “Autogyro Navigator” made by Andrews. For a 4×4 m square path the dead-reckoning error when using this gyro was less than ±1.2° in...

There are several application areas where the simultaneous measurement of rates of rotation about three mutually orthogonal axes is required. In this paper the principle features of a 3-axis vibrating ring gyroscope are described. The fabrication process for the gyroscope is presented and employs standard MEMS techniques. The modal properties for the ring are measured experimentally using laser...

Silicon-MEMS gyroscope is an important part of MEMS ( Micro Electrical Mechanical System). There are some disturb ignored in traditional gyroscope that must be evaluated newly because of its smaller size (reach the level of micron). In these disturb, the air pressure largely influences the performance of the MEMS gyroscope. Different air pressure causes different gas damping coefficient for the...

Micromachined gyroscopes for measuring rate or angle of rotation have attracted a lot of attention during the past few years for several applications. They are widely used to detect orientation in space, including automotive applications for ride stabilization and rollover detection; some consumer electronic applications, such as video-camera stabilization, virtual reality, and inertial mouse f...

In order to improve the precision of the low cost MEMS gyroscope and reduce the influence of the random drift error on the measurement system. In this paper, the Allan variance method, mean filtering method, time series analysis method and Kalman filtering technique are used to analyze and filter the random error of static output of MEMS gyroscope. The results show that the amplitude of the ran...

William Fairbank is tremendously lucky-or is he clairvoyant? He initiated the Stanford gyroscope experiment in 1961 as a search for the dragging of inertial frames by the earth's rotation-an effect so small as to be interesting in principle, but not in practice. However, today, twenty years later, just when technology development for the gyroscope experiment has reached completion, the theoreti...

System Dynamics and Adaptive Control for MEMS Gyroscope Sensor Juntao Fei1,2 and Hongfei Ding2 1Jiangsu Key Laboratory of Power Transmission and Distribution Equipment Technology 2College of Computer and Information, Hohai University, Changzhou, 213022, P. R. China Abstract: This paper presents an adaptive control approach for Micro‐Electro‐Mechanical Systems (MEMS) z‐axis gyroscope sensor....