Overall system calibration is one limiting factor in direct georeferencing. Within this context the stability of system calibration over longer time periods and the influence of additional self-calibration is of special interest. The investigations presented are based on test material from a real flight test, where a calibration field was flown several times within a two month period using the ...

PURPOSE To demonstrate that the temporal signal-to-noise ratio (SNR) of generalized autocalibrating partially parallel acquisitions (GRAPPA) accelerated echo planar imaging (EPI) can be enhanced and made more spatially uniform by using a fast low angle shot (FLASH) based calibration scan. METHODS EPI of a phantom and human brains were acquired at 3 Tesla without and with GRAPPA acceleration f...

In the present study, the amount of nitrate and phosphate leaching from agricultural lands into the Zanjanrood River in Iran was simulated using the Soil & Water Assessment Tool (SWAT) model. The measured average monthly discharges at the Sarcham station were used to calibrate and validate the SWAT model, and the SWAT Calibration and Uncertainty Program (SWAT-CUP) model was applied to perform t...

The assessment of the recovery factor with the analyte concentration in meat samples has been studied for the determination of organochlorine and organophosphorus pesticides in meat by gas chromatography-triple quadrupole mass spectrometry (GC-MS/MS). For that purpose, recent IUPAC recommendations, which distinguishes between two terms, recovery factor and apparent recovery, have been followed....

Introduction CR-39 detectors are widely used for Radon and progeny measurement in the air. In this paper, using the Monte Carlo simulation, the possibility of using the CR-39 for direct measurement of Radon and progeny in water is investigated. Materials and Methods Assuming the random position and angle of alpha particle emitted by Radon and progeny, alpha energy and angular spectrum that arri...

A three years study on precision farming in cotton in central Greece showed serious infield variability of yield and soil physical and chemical properties. Yield mapping constitutes the starting and ending point of the whole process chain in a precision farming system. Yield mapping was performed for three consecutive years in the same cotton fields of central Greece in a wide range of cotton v...

In the fields of electromagnetic interference and electromagnetic compatibility, it is important to measure the strength of the electric field originating from electric devices. For this purpose, knowledge of the antenna factor of a receiving antenna is necessary. According to international standards, the accurate measurement of the antenna factor involves the use of calibration test sites char...

The need for calibration arises frequently in the use of strain gage instrumentation. Periodic calibration is required, of course, to assure the accuracy and/or linearity of the instrument itself. More often, calibration is necessary to scale the instrument sensitivity (by adjusting gage factor or gain) in order that the registered output correspond conveniently and accurately to some predeterm...

The method we propose simpli es the practical procedure for hand eye calibration Indeed no more calibration jig is needed and small calibration motions can be used Without calibration jig camera motions are computed up to an unknown scale factor through structure from motion algorithms rather than pose estimation This work was supported by the European Community through the Esprit IV reactive L...

In this paper an improved method for calibrating wide-angle, fisheye and omnidirectional imaging systems is presented. We extend the calibration procedure proposed by Scaramuzza et al. by replacing the residual function and joint refinement of all parameters. In doing so, we achieve a more stable, robust and accurate calibration (up to factor 7) and can reduce the number of necessary calibratio...