Enzymatic saccharification (Hydrolysis) is one of the technologies to hydrolyze lignocellulosic biomass. In this study, Bangladeshi bagasse is used as feedstock for enzymatic saccharification and ethanol fermentation. Cutter mill and Mechano-chemical treatment (Ball mill) are used for pretreatment. The main objective of this study is to investigate the effect of substrate concentration, pretrea...

This research is focused on the Phase I SABC milling circuit of the Wushan porphyry copper mine. Improvements to the existing circuit were targeted without any significant alterations to existing equipment or the SABC circuit. JKSimMet simulations were used to test various operating and design conditions to improve the comminution process. Modifications to the SABC comminution circuit included ...

High energy ball mills are used to grind powder material down to a particle size below one micron. Up to now, the detailed physical mechanisms of the grinding process inside the mill have not been fully understood. Hence, the design of these mills as well as their process parameters is based on empirical results. The ball mill has been simulated by discrete event simulation (DES) using typical ...

In this work, a blend of Ti, Nb, and Mn powders, with nominal composition 15 wt.% Mn, balanced Ti Nb wt.%, was selected to be mechanically alloyed by the following two alternative high-energy milling devices: vibratory 8000D mixer/mill® PM400 Retsch® planetary ball mill. Two ball-to-powder ratio (BPR) conditions (10:1 20:1) were applied, study evolution synthesized phases under each mechanical ...

Reliable measurements of ball mill load parameters and reorganization of the operating statuses are the key factors for saving energy and optimization control. Empirical mode decomposition (EMD) and partial least squares (PLS) are used to analyze shell vibration signal and monitor mill load parameters of ball mill. The shell vibration signal is decomposed into several intrinsic mode functions (...

OBJECTIVE The main purpose of this paper is to present a new method of predicting clinical performance using mechanical loading in a ball mill. METHODS A series of four experiments (two involving a hybrid composite and one each on orthodontic brackets and bands) is described in which the ball mill was used to subject specimens to mechanical fatigue. RESULTS A reproducibility study using com...

The thesis is focussed on low consistency (LC) refining of mechanical pulp. The research included evaluations of energy efficiency, development of pulp properties, the influence of fibre concentration on LC refining and effects of rotor position in a two-zoned LC refiner. Trials were made in mill scale in a modern TMP line equipped with an MSD Impressafiner for chip pre-treatment, double disc (...