in this article our objective is to obtain steady state characteristics of shunt, series, and separately excited dc motors coupled with a centrifugal water pump supplied through a step-up, step-down, and cuk converter from photovoltaic generator. we assume that there are no storage batteries and, of course, the system must operate on maximum utilization i.e. maximum water must be pumped. it is ...

the monolithic catalytic converter is still the main pollution control device for modern vehicles in order to reach the ever-increasing legislative demands for low emission standards. the catalytic converters require a large expansion from the exhaust pipe to the front face of the monolith. unfortunately, packaging constraints often do not permit the use of long diffusers. hence, flow separatio...

In this paper, sliding mode control (SMC) for a bidirectional buck/boost DC-DC converter (BDC) with constant frequency in continuous conduction mode (CCM) is discussed. Since the converter is a high-order converter, the reduced-order sliding manifold is exploited. Because of right-half-plan zero (RHPZ) in the converter’s duty ratio to output voltage transfer function, sliding mode current...

In this paper, a generalized buck-boost Z-H converter based on switched inductors is proposed. This structure consists of a set of series connected switched-inductor cells. The voltage conversion ratio of the proposed structure is adjusted by changing the number of cells and the duty cycle. Like the conventional Z-H converter, the shoot-through switching state and the diode before LC network ar...

conclusions the ammonia degassing is a simple and suitable technology for ammonia removal at high concentration. undesirable removal efficiency (17%, 35.5% and 31%) can be occurred in suitable ph 11 in the presence of lower ammonia concentrations (50, 100 and 200 mg/l). results according to obtained results, the maximum removal efficiencies were determined 17%, 35.5%, 31%, 66%, and 85.5%, for 5...

in this paper, a new topology is proposed for three-phase to single-phase matrix converters, where more voltage levels are produced in the output in comparison with the conventional topologies. in addition, a new control method based on minimum error between the generated and the desired output voltages is proposed for three-phase to single-phase matrix converters. in the proposed control metho...

Z-Source converter or impedance-source converter is a kind of power converters, which has the responsibility to convert the direct current to alternative current. This converter with respect to its circuit diagram acts as a buck-boost converter except it doesn’t use from DC-DC converter bridge. Γ-source inverters are one of the conventional converters based on impedance-sources; which have been...