The effect of chemical composition and the hot rolling operations on the microstructure and mechanical properties of in situ aluminum matrix composite with Mg2Si phase as the reinforcement was studied. It was revealed that the modification by phosphorous results in the rounder (more spherical) primary and secondary (eutectic) magnesium silicide intermetallics. During hot rolling, the primary pa...

A laminated Ti-Al composite has been fabricated by hot compaction and hot rolling of alternate layers of commercial purity Ti and Al sheets with a thickness of 200 μm. The hot compaction temperature was 500 ̊C and in a following step the composite has been reduced 50% in thickness by hot rolling. The fully consolidated composite has been annealed at 300 ̊C and 500 ̊C for different length of time. ...

Polymer-clay composites were designed to adsorb selenium from water. The highest adsorption efficiency was obtained for chitosan-montmorillonite composites. These composites were characterized by XRD, zeta potential, and FTIR measurements. Adsorption isotherms of selenate on the composite, on Al-oxide and on Fe-oxide were in good agreement with the Langmuir model, yielding a somewhat higher cap...

Abstract: Nano-structural synthesized materials can be fabricated utilizing intensive milling after combustion synthesis. The Al2O3-TiB2 ceramic composite has been synthesized by aluminothermic reactions between Al, Ti (TiO2), and B (B2O3 or H3BO3). Boric acid (H3BO3) is less expensive than boron oxide, and after being dehydrated at 200°C, boron oxide will be obtained. In this study, Al, TiO2, ...

In this investigation ‚the fracture toughness of A356 containing15%SiC composite was studied. Al/SiC composites have been considered because of their mechanical and erosion properties .Low fracture toughness in Al/SiC as compared with Aluminium alloys is one of its disadvantage. In this study at first A356 alloy was melted in a smelting electrical furnace then poured into the mould. A356-15% Si...

This Investigation studies the Mechanical and Tribological behaviour [ i.e dry sliding behaviour] of Al matrix composites reinforced with SiC and Gr particulate up to 10%, to study the effect of reinforcement, Load, Sliding speed and Sliding distance on stir cast Al-SiC and Al-Gr Metal matrix composites. Parametric studies indicate that the hardness, tensile strength of Al-SiC composite is grea...

Thermal explosion mode of combustion synthesis was used to fabricate TiAl-Al2O3 and TiAl-Ti2AlC-Al2O3 composites from elemental powder mixtures of TiO2, Al and C and characterized by XRD and Scanning Electron Microscopy (SEM) coupled with Energy-Dispersive Spectroscopy (EDS). The experimental results showed that thermite reaction of Al with TiO2 caused TiAl-Al2O3 composite formation. By adding ...

Friction stir processing was applied for fabricating an aluminum alloy based hybrid nano composite reinforced with nano sized Al2O3 and micro sized graphite particles. A mixture of Al2O3 and graphite particles was packed into a groove with 1 mm width and 4.5 mm depth, which had been cut in 5083 aluminum plate of 10 mm thick. Packed groove was subjected to friction stir processing in order to im...