An experimental test was carried out to explosively clad solution annealed Inconel 718 superalloy on quench-tempered AISI H13 hot tool steel. A wavy with vortices interface geometry was obtained from this experiment. A gradual change in the wavelength along the direction of welding was observed which was due to a change in the impact angle, following the plate contacts. In this paper, the exper...

In this study, machinability tests on Assab Korkmaz Orvar Supreme (1.2344 ESR, AISI H13 Premium) hot work tool steel widely used in industry were carried out. Machinability tests were carried out through single point turning method at eight different cutting speeds (120, 160, 200, 240, 280, 320, 360 ve 400 m/dak), four different feed rates (0,05; 0,10; 0,15 and 0,20 mm/min) and 1 mm depth of cu...

Tooling in the die and mould industry is subjected to high-wear high-temperature environments, which often leads premature failure of this high-added-value tooling. When severe damage occurs, an alternative replacing whole component consists repair by laser-directed energy deposition (L-DED). For that end, intermediate layers are commonly employed as buffer material, where introducing a functio...

Abstract The paper focuses on researching the effect of fatigue loading metallic structure, lifetime, and fracture surface topographies in AISI H13 steel specimens obtained by selective laser melting (SLM). topography surfaces was measured over their entire area, according to total area method, with an optical three-dimensional measurement system. results SLM 3D printed were compared those repo...