Renewable energy sources are being widely used for Distributed Generation (fuel cells, solar panels, Wind power generators etc..,) because of their advantages. But they produce a very low output voltage. To interconnect a low-dc-voltage to residential loads a special voltage matching converter is required. This paper presents a back to back connection of cascaded quasi-Z-source network based st...

Impedance converters have been developed as a new type of converter besides the two other existing converters: voltage-source and current source converters. The new converter has many inherent advantages which can be used for many applications such as wind power conversion system, fuel cell system or motor drive applications. Present research works are mostly focused on using Z-source network a...

Most mobile equipments use battery as power source. The increasing use of low voltage portable devices and growing requirements of functionalities embedded into such devices. Thus an efficient power management technique is needed for longer battery life for them. Given the highly variable nature of batteries systems often require supply voltages to be both higher and lower than the battery. Thi...

An Integrated double buck boost converter is analyzed and the design methodology is made as a high power factor of the power supply for the power LED lamps. The IDBB converter features just one controlled switch and two inductors and is able to supply a solid-state lamp from the mains, providing high power factor. Here with a careful design of the converter, the filter capacitances can be made ...

the aim of this paper is to design a fractional order sliding mode controllers (fosmc)for a class of dc-dc converters such as boost and buck converters. firstly, the control lawis designed with respect to the properties of fractional calculus, the design yields an equiv-alent control term with an addition of discontinuous (attractive) control law. secondly, themathematical proof of the stabilit...

1 This work is supported by Philips Research, Briarcliff Manor, NY, through Colorado Power Electronics Center Abstract – In converters for power-factor-correction (PFC), universal-input capability (ability to operate from any AC line voltage, world-wide) comes with a heavy price in terms of component stresses and losses, size of components, and restrictions on the output DC voltage. A new two-s...

Abstract – Resonant parametric perturbation (RPP) method is an effective non-feedback method for controlling chaos. In this paper, the above method is applied for the current programmed buck-boost dc-dc converter which exhibits chaotic for wide parameter variations. The different possible operating regimes leading to chaotic operation of the current mode controlled buck-boost converter is discu...

A Double input DC to DC converter for low voltage energy sources applications is proposed in this paper. The proposed converter is buck-boost converter which can step up or step down the input voltage according to output voltage required at load end. The converter is able to boost up voltage of energy sources such as solar photovoltaic and wind energy system of relatively low voltage. The conve...

Addition of an input filter to a current-programmed converter can cause the controller to oscillate. Two instability mechanisms can typically occur: 1) the current programmed controller effective current feedback loop may become unstable, or 2) the controller effective input voltage feed forward loop, which becomes a positive feedback loop when an input filter is added, may oscillate. Design cr...

The voltage source inverter (VSI) and current voltage source inverter (CSI) are widely used in industrial application. But the traditional VSIs and CSIs have one common problem: can’t boost or buck the voltage come from battery, which make them impossible to be used alone in Hybrid Electric Vehicle (HEV/EV) motor drive application, other issue is the traditional inverter need to add the dead-ba...