Influence of distributed generation systems in the distribution systems can increase the level of short-circuit current. The effectiveness of distributed generation systems is affected by the size, location, type of distributed generation systems technology, and the methods of connecting to distribution systems. Wind turbine system is the examples of distributed generation source. Not only does...

among the all parameters affecting the performance of a downhole de-oiling hydrocyclone, the investigation of internal flow field deserves more attempts especially in the petroleum industry. in this study, the effects of inlet flow rate, inlet oil volume fraction, and oil droplet diameter on the separation efficiency and pressure drop ratio have been investigated along the hydrocyclone body. al...

the fluid flow and heat transfer in a three-dimensional microchannel filled with al2o3- water nanofluid is numerically investigated. the hybrid scheme is used to discretize the convection terms and simpler algorithm is adopted to couple the velocity and pressure field in the momentum equations. the thermal and flow fields were analyzed using different volume fractions of nanoparticles and diffe...

This paper reanalysed the 255 sets of geothermal two-phase flow data of Freeston et al (1983). A new void fraction correlation is proposed in this paper. The new correlation is derived from the analysis of two-phase flow velocity distribution using the Seventh Power Law as: To predict the two-phase pressure drop, an equivalent pseudosingle-phase flow having the same boundary layer velocity dist...

0

The Diffuser Augmented Wind Turbines (DAWTs) have been widely studied, since the diffusers improve the power coefficient of the wind turbine, particularly of small systems. The diffuser is a device which has the function of causing an increase on the flow velocity through the wind rotor plane due to pressure drop downstream, therefore resulting in an increase of the rotor power coefficient. Thi...

Draft tube of Francis type hydraulic turbine usually consists of: cone, elbow and diffuser. On the contrary, in some power stations an extra pipe should be added to the draft tube at the bottom of cone because of installation limitation. In this paper, this special case has been numerically studied. To this end CFD analysis was applied to simulate all parts of hydraulic turbine. A homogeneous m...

In this study, operation of compressor station has been investigated by exergy approach. Exergy analysis is a thermodynamic method which shows the irreversibility of a system quantitatively. Gas compressors are used to compensate the pressure drop along the gas pipeline significantly. The compression process causes temperature rise of gas; in this regard gas cooler is applied to reduce the temp...

the pressure drop of refrigerant r-134a flow boiling inside a horizontal tube has been investigated experimentally. the test set-up which was used in this investigation is a well instrumented vapor compression refrigeration system. these instruments are thermocouples, flow meter, pressure gauges and the pressure drop measuring apparatus. this system consisted of three electrically heated evapor...

a canola seed pneumatic conveyor was designed and constructed to convey canola seed at a 90 g/hr mass flow rate through a 58 mm diameter pipe. physical and aerodynamic properties of the canola seed that are critical to the design process were measured. system pressure drop, comprising air pressure drop and solid pressure drop and which is the most important aspect of pneumatic conveyor design, ...