The menisci protect the articular cartilage by reducing contact pressure in the knee. To restore their function after injury, a new silk fibroin replacement scaffold was developed. To elucidate its tribological properties, friction of the implant was tested against cartilage and glass, where the latter is typically used in tribological cartilage studies. The silk scaffold exhibited a friction c...

This paper reports on the effects of nitrogen dilution on the structure, bonding and tribological properties of nitrogendoped amorphous carbon films (a-C:H:N) deposited by r.f. glow discharge from CH4-N2 mixtures on silicon substrates. For different N2 fractions, film structure and chemical composition were examined using Raman spectroscopy and X-ray photoelectron spectroscopy (XPS). The mechan...

Biopolymers reinforced with nanoparticle (NP) additives are widely used in tribological applications. In this study, the effect of NP additives on the tribological properties of a green lubricant hydroxypropyl methylcellulose (HPMC) composite was investigated. The IF-MoS₂ NPs were prepared using the newly developed gas phase sulfidation method to form a multilayered, polyhedral structure. The n...

Graphene oxide (GO) can be readily modified for particular applications due to the existence of abundant oxygen-containing functional groups. Graphene oxide-based materials (GOBMs), which are biocompatible and hydrophilic, have wide potential applications in biomedical engineering and biotechnology. In this review, the preparation and characterization of GO and its derivatives are discussed at ...

This paper describes the results of tests on the influence of human saliva and its substitutes on tribological characteristics of friction pairs. Each pair consists of enamel and one of the following materials: ceramics, the Meridian B2 dental composite, the GK dental amalgam, and Ti-6Al-4V titanium alloy. The saliva substitutes used were prepared using pyrophosphates, xanthan gum, and mucins d...

Environmentally friendly multipurpose grease formulation has been synthesized by using Jatropha vegetable residual oil with lithium soap and multifunctional additive. The thus obtained formulation was evaluated for its tribological performance on a four-ball tribo-tester. The anti-friction and anti-wear performance characteristics were evaluated using standard test methods. The biodegradability...

Functional additives, particularly extreme pressure and antiwear additives, in formulated oil will compete to adsorb and function in tribological contacts. A low-polarity commercial base oil, poly-α-olefin (PAO), blended with zinc dialkyl dithiophosphates (ZDDP) has been studied. The tribological performance was evaluated using a ball-on-disk test rig under mixed rolling-sliding conditions in t...

Tribological properties of nanolamellar tungsten disulfide doped with zinc oxide nanoparticles were studied. Nanolamellar tungsten disulfide and ZnO nanoparticles produced by electrospark erosion of metal granules in an H2O2 solution were analyzed using the XRD, SEM and TEM techniques. According to the tribological measurements, ZnO nanoparticles did not significantly change the friction coeffi...

Citation: Barnhill WC, Gao H, Kheireddin B, Papke BL, Luo H, West BH and Qu J (2015) Tribological bench and engine dynamometer tests of a low viscosity SAE 0W-16 engine oil using a combination of ionic liquid and ZDDP as anti-wear additives. Front. Mech. Eng. 1:12. doi: 10.3389/fmech.2015.00012 Tribological bench and engine dynamometer tests of a low viscosity SAE 0W-16 engine oil using a combi...

AbstractSputtered MoS2 coatings have been mostly used as a solid lubricant. In this investigation, MoSx/Ni composite coatings with Ni contents varying from 0 to 22 % were deposited onto steel substrate using a DC magnetron sputter process. The MoS2/Ni ratio in the coatings was controlled by sputtering the composite targets. The composition, microstructure, and mechanical properties of the...