This investigation aimed to fabricate a flexible micro resistive temperature sensor to measure the junction temperature of a light emitting diode (LED). The junction temperature is typically measured using a thermal resistance measurement approach. This approach is limited in that no standard regulates the timing of data capture. This work presents a micro temperature sensor that can measure te...

A novel method of measuring the relative headmedium spacing based on a measurement in the servo sectors is developed and simulated using a read back signal model. The spacing measurement is tested experimentally on a spin stand where the flying height is varied using the resistance heater element in a thermal flying height control slider. In addition, voltage step response measurements were obt...

A novel thermal anemometry grid sensor was developed for the simultaneous measurement of cross-sectional temperature and axial velocity distribution in a fluid flow. The sensor consists of a set of platinum resistors arranged in a regular grid. Each platinum resistor allows the simultaneous measurement of fluid temperature via electrical resistance and flow velocity via constant voltage thermal...

Sputtered reactive multilayers applied as a heat source in electronic joining processes are an emerging technology. Their use promises low-stress assembly of components while improving thermal contact and reducing thermal resistance. Nanostructured surface modifications can significantly enhance adhesion and reliability of joints between different materials. This work examines reactive multilay...

We have measured the thermal resistance of a 152-nm-diameter carbon nanofiber before and after a platinum layer was deposited on the contacts between the nanofiber and the measurement device. The contact resistance was reduced by the platinum coating for about 9–13% of the total thermal resistance of the nanofiber sample before the platinum coating. At a temperature of 300 K, the axial thermal ...

Vertical carbon nanotube (CNT) forests bonded at room temperature with sprayed on nanoscale polymer coatings are found by measurement to produce thermal resistances that are on a par with those of conventional metallic solders. These results are achieved by reducing the high contact resistance at CNT tips, which has hindered the development of high performance thermal interface materials based ...

An apparatus has been designed and constructed to characterize thermal interface materials with unprecedented precision and sensitivity. The design of the apparatus is based upon a popular implementation of ASTM D5470 where well-characterized meter bars are used to extrapolate surface temperatures and measure heat flux through the sample under test. Measurements of thermal resistance, effective...