cracked and un-cracked brazilian disc specimens subjected to diametral compression were used for conducting fracture toughness and tensile strength experiments on a polymer concrete (pc) material. the value of mode i fracture toughness (kic) was determined from the center- cracked brazilian disc and the indirect tensile strength (σt) was obtained from the un-cracked brazilian disc specimen. the...

It is known that the single-modal Weibull model describes well the size effect of brittle fiber tensile strength. However, some ceramic fibers have been reported that single-modal Weibull model provided biased estimation on the gauge length dependence. A hypothesis on the bias is that the density of critical defects is very small, thus, fracture probability of small gauge length samples distrib...

Composite materials utilizing the sandwich structure are a basic family of materials and possess a highly increasing use in modern industrial applications. Since the traditional approach to structural design and material selection tends to be replaced by the Fracture mechanics approach, it is worth understanding the way that the Fracture mechanics approach is applied. The traditional approach t...

The effect of static and cyclic loading conditions on the stress corrosion cracking of unidirectional glass reinforced polymer (GRP) rods used in composite high voltage insulator has been investigated. A series of stress corrosion experiments have been performed on unidirectional E-glass/modified polyester composite rods. The rods have been subjected to mechanical tensile static and cyclic stre...

In several practical cases, the ultimate ductile fracture strain determined with tensile test is accepted as a material plasticity measure 1 . In this case, the plasticity has to be defined as an ability of a material to accommodate high permanent strains until fracture appears where this strain reaches certain value called ultimate fracture strain p. The strain value until fracture depends not...

Shale formations show obvious anisotropic characteristics in their mechanical properties due to pronounced bedding planes and natural fractures. This anisotropic behavior generally creates complex fracturing networks and is crucial to gas shale stimulation. Although much research has been done to study the anisotropic compression behaviors of shale with static and quasi-static strain rates, the...

Recent accreditation of titanium powder products for commercial aircraft applications marks a milestone in titanium powder metallurgy. Currently, powder metallurgical titanium production primarily relies on vacuum sintering. This work reported on the feasibility of powder sintering in a non-vacuum furnace and the tensile properties of the as-sintered Ti. Specifically, we investigated atmospheri...

fast fracture is one of the major failure modes in brittle polymers. generally, crack growth in these polymers may occur under combined tensile-shear loading. however, the fracture test data reported previously for some dental restorative resins can not be predicted by using the available fracture criteria.in this paper, a modified fracture criterion is used for estimating the fracture load for...

Plain concrete structures such as dams or retaining walls, as well as rock structures such as tunnels, caverns, excavations, and rock slopes, have commonly been designed by elastic-perfectly plastic analysis in which the tensile yield strength of the material is taken as zero. The paper analyzes the safety of this "notension" design in the light of the finiteness of the tensile strength of conc...

An Aluminum based in-situ alloy reinforced with Mg2Si and Si hard particles produced by casting Al-6Si-0.5Mg alloy. The microstructure, tensile properties and fracture behavior of the alloy were investigated and the results show that the Mg2Si and Si hard particles produced by precipitation hardening have great effects. The homogenized (24hr at 500 o C) and solutionized (2hr at 540 o C) cast al...