Comparator based switched capacitor circuits provide an excellent opportunity to design sampled data systems where the virtual ground condition is detected rather than being continuously forced with negative feedback in Opamp based circuits. This work is an application of this concept to design a 1 order 330 KHz cutoff frequency Lowpass filter operating at 10 MHz sampling frequency in 0.13μm te...

In order to miniaturize a very low-level dc current amplifier and to speed up its output response speed, we proposed to employ the switched-capacitor circuit (SCC) as its negative feedback circuit, instead of the conventionally used high-ohmage resistor. However, in the case of using SCC, the output waveform had unnecessary components. To decrease the effect of these components and to speed up ...

A low voltage switched-capacitor circuit that generates an almost constant reference current across process, voltage and temperature (PVT) is proposed. The reference voltage is generated by a low voltage band-gap circuit. The output reference current is obtained by applying the generated reference voltage to a low voltage V – I converter. The resistor in the proposed V – I converter is further ...

This paper advances a fuzzy control strategy of the phase angle between the voltage and the current of a variable RL load using the system introduced in [3]. This control method is-easy to adapt for performance The paper presents a practical implementation of a fuzzy controller for the control of an induction motor. control of power factor in a circuit with variable inductive load using a switc...

A power management controller circuit with a switched-capacitor mode down-regulator and a battery charger block for semi-active radio-frequency identification (RFID) tags was proposed and fabricated. The major achievement of the proposed switched-capacitor mode downregulator and battery charger block is providing a low standby current internal voltage supply circuit and self-controlled thin fil...

An alternative method for characterizing capacitor matching is presented. The basic idea of this method is to sense the mismatch among the capacitors by amplifying the error voltage using an iterative switched-capacitor scheme. Through simulation, this method has shown attractive property for sensing capacitor mismatches down to 1% and smaller.

In this paper, two possible switched capacitor implementations of companding lters are discussed. The governing di erence equations, an estimate of the increase in the dynamic range for a given power consumption and possible topologies are given.

The paper deals with a new 12-bit low power switched-capacitor (SC) ADC for portable applications, such PDA, notebook etc. The paper describes design of ADC and its behavioural modelling regarding low power consumption. The Op-Amp sharing technique and capacitor scaling approach are utilized to obtain it. The basic block topology design is outlined too. The cancellation techniques to avoid the ...