In the present paper, the evolution of an oxidation process has been associated to the collective atomic arrangement, the microstructure one. This microstructural analysis encompasses a metallographic examination and a relation of electricity to chemical changes in salt-water solution. The electrochemical experimental techniques used include corrosion potential measurements. To seek a deeper un...

The SiC particles (SiCp, mass fraction 30 %) reinforced with the Al-Si-Cu-Mg matrix composite have been prepared using one-way press method, sintering, and hot extrusion. The composite was subjected to solid solution treatment at temperatures of 470 °C, 485 °C, 500 °C, 515 °C, and 530 °C for 4 h. The sample was then subjected to ageing treatment at temperatures of 160 °C and 180 °C during diffe...

It is well known that semi-solid forming could only obtain coarse-grained microstructure in a few alloy systems with a low melting point, such as aluminum and magnesium alloys. This work presents that semi-solid forming could also produce novel bimodal microstructure composed of nanostructured matrix and micro-sized (CoFe)Ti2 twins in a titanium alloy, Ti62Nb12.2Fe13.6Co6.4Al5.8. The semi-solid...

High permittivity barium titanate zirconate (BTZ) is often used for dielectrics in commercial multilayer ceramic capacitors, actuators applications, and is a highly promising material for dynamic random access memory (DRAM) and microelectromechanical system (MEMS) applications due to its very stable, high insulating characteristic against voltage. Especially, the material is promising for envir...

in this research, mechanical alloying was used to produce ti-50al, ti-45al-5cr and ti-45al-5w (at%) alloys. the effect of ternary addition (cr and w) on microstructure and production efficiency of tial alloy were investigated. alloying was performed in a planetary mill and the milling time varying from 5 to 70h. the structural evaluation in these powders was done by x-ray diffraction (xrd) tech...

The effects of a third element, namely silver, copper, zinc, or antimony, on the microstructure and mechanical properties of eutectic tin-bismuth (Sn–Bi) solder were investigated. The investigation showed that, except for zinc, the addition of a trace amount of the third element improves the ductility of the Sn–Bi solder owing to the formation of a fine, homogeneous ternary eutectic microstruct...

The change of microstructure of the title alloys with concentration, temperature and applied thermal treatment was studied in situ by XRD. The alloys, having the Zn atomic fraction, x(Zn), from 0.03 to 0.62, were subjected to: (i) rapid quenching from a temperature, Tt, higher than the solid-solution temperature, Tss, in water at RT (samples WQ); (ii) slow cooling from Tt to RT (samples SC). Th...

The microstructure and mechanical properties of 7075 wrought aluminum alloy produced by strain induced melt activation (SIMA) route were investigated.Also liquid volume fraction measurement was studied by three procedures. Remelting process was carried out in the range of 560 to 610 °C for 20 min holding. The microstructure in the semi-solid state consists of fine spherical solid grains surroun...