In hot forming process, the workpiece undergoes plastic deformation at high temperature and the microstructure of the workpiece changes according to the plastic deformation. These changes affect the mechanical properties of workpiece. In order to optimize this process, both the plastic deformation of workpiece and its microstructural changes should be taken into consideration. Since material be...

Thin shell torispherical pressure vessel heads are known to exhibit complex elasticplastic deformation and buckling behaviour under static pressure. In pressure vessel Design by Analysis, the designer is required to assess both of these behaviour modes when specifying the allowable static load. The EN and ASME Boiler and Pressure Vessel Codes permit the use of inelastic analysis in design by an...

Thin shell torispherical pressure vessel heads are known to exhibit complex elasticplastic deformation and buckling behaviour under static pressure. In pressure vessel Design by Analysis, the designer is required to assess both of these behaviour modes when specifying the allowable static load. The EN and ASME Boiler and Pressure Vessel Codes permit the use of inelastic analysis in design by an...

the aim of the present study was to prepare an oral tablet from liquid yogurt by reforming the physical properties for easy transportation, long-term storage and also as a complementary dairy product in case of nutrient deficiency. the liquid fresh yogurt was lyophilized at -40°c and 0.03 mtor pressure. the dry powder was homogenized by a 12 mesh size sieve. some tests such as carr’s compressib...

Under mechanical loading, most living cells show a viscoelastic deformation that follows a power law in time. After removal of the mechanical load, the cell shape recovers only incompletely to its original undeformed configuration. Here, we show that incomplete shape recovery is due to an additive plastic deformation that displays the same power-law dynamics as the fully reversible viscoelastic...

An empirical method of non-destructive testing of a material was developed using pulse transmission by acoustic emission transducers to determine plastic deformation of 304 stainless steel specimens. This was done by means of comparison of pulse signals detected in an undeformed section with the pulse signals detected after passing through the deformation zone in the specimens. The pulse signal...

Contact between a slider and bit patterned media (BPM) is investigated using finite element analysis. The effect of contact conditions and material properties at the interface between slider and disk on plastic deformation and temperature is studied. In addition, the planarization of bit pattern media on temperature and plastic deformation is investigated for different filler materials. It is f...

Plastic deformation behavior of Cu/Ni/W metallic multilayers with individual layer thickness ranging from 5 nm to 300 nm is investigated by nanoindentation testing. The experimental results reveal that the composite still exhibits indentation-induced plastic deformation instability and the loss of strain hardening ability at the nanometer scale even if the composite contains two kinds of layer ...

over the last two decades, many researchers have developed a variety of stainless steel-based medical implant types,taking full advantage of nanostructuring technologies. in this paper the application, fabrication and development of nanostructured stainless steel based materials with new composition for medical implants will be discussed. it is well established that application of severe plasti...