A broadband radial waveguide power amplifier has been designed and fabricated using a spatial power dividing/combining technique. A simple electromagnetic model of this power-dividing/combining structure has been developed. Analysis based on equivalent circuits gives the design formula for perfect power-dividing/ combining circuits. The measured small-signal gain of the eight-device power ampli...

The operation of Fuel Cell Distributed Generation (FCDG) systems in distribution systems is introduced by modeling, controller design, and simulation study of a Solid Oxide Fuel Cell (SOFC) distributed generation (DG) system. The physical model of the fuel cell stack and dynamic models of power conditioning units are described. Then, suitable control architecture based on fuzzy logic contro...

In passive, linear, and monochromatic systems, complete phase-insensitive combining of powers carried by waves from several input channels into a single output channel is forbidden the energy conservation law. Here, we demonstrate that combination both coherent incoherent plane can be achieved using metasurfaces with properties varying in space time. The proposed structure reflects same frequen...

Growing demand on special signal modulation schemes in novel radars and ability to transmit relatively long pulses cause the Travelling Wave Tubes (TWT) to be constantly replaced by new concepts of power amplifiers. Solid-state power amplifiers appear to be a good candidate, however, the output power from a single transistor module is still relatively low. The only available solution is that of...

High power, broad bandwidth, high linearity, and low noise are among the most important features in amplifier design. The broad-band spatial power-combining technique addresses all these issues by combining the output power of a large quantity of microwave monolithic integrated circuit (MMIC) amplifiers in a broad-band coaxial waveguide environment, while maintaining good linearity and improvin...

A four-device broadband solid-state power amplifier, which is based on radial waveguide power-dividing/combining circuit, has been investigated in this work. The fabricated power amplifier combining four monolithic microwave integrated circuit power amplifiers shows a 12–16.6 dB small-signal gain over a broadband from 6 to 14 GHz. The measured maximum output power at 1 dB compression is 25.6 dB...

A new non-linear method for design and analysis of solid state power amplifiers is presented and applied to an aluminum gallium nitride, gallium nitride (AlGaN-GaN) high electron-mobility transistor (HEMTs) on silicon-carbide (SiC) substrate for Ku band (12.4 13.6 GHz) applications. With combining output power of 8 transistors, maximum output power of 46.3 dBm (42.6 W), PAE of 43% and linear ga...