Previous studies have shown favourable properties for papaya bast fibres, with a Young's modulus of up to 10 GPa and a tensile strength of up to 100 MPa. Because the fibres remain as residues on papaya plantations across the tropics in large quantities, their use in the making of green composites would seem to be worthy of consideration. This study aims to show that such composites can have ver...

Here we propose a macroscopic model for elasto-plastic composite, characterized by an initial anisotropy, that can evolve during the large plastic deformation. Application to transversely isotropic and orthotropic composites will be also developed. The paper deals with anisotropic finite elasto-plastic 6-models, which accounts for the dissipative nature of the plastic flow, within the construct...

The tensile plastic deformation of dendrite-reinforced Ti-based metallic glass composites (MGCs) was investigated. It was found that there is a critical normalized strain-hardening rate (NSHR) that determines the plastic stability of MGCs: if the NSHR is larger than the critical value, the plastic deformation of the MGCs will be stable, i.e. the necking and strain localization can be effectivel...

We consider fiber reinforced composites where both the matrix and the fibers are ideally plastic materials. We restrict our attention to microstructures and applied stresses that lead to both microscopic and macroscopic antiplane shear deformations. We describe a bound we have recently obtained on the yield set of the composite in terms of the shape of the fibers, their volume fraction, and the...

the accumulative roll bonding process is used as a severe plastic deformation technique to produce aluminum composite sheets with ultra fine structure. in this study the effect of simultaneous use mg and sic particles as reinforcements, on the tensile properties of the al-mg-sic hybrid compositeis studied. the al-mg-sic hybrid composites with different amounts of mg and sic contents were fabric...

With regard to previous tensile deformation models simulating the tensile behavior of in-situ dendrite-reinforced metallic glass matrix composites (MGMCs) [Qiao et al., Acta Mater. 59 (2011) 4126; Sci. Rep. 3 (2013) 2816], some parameters, such as yielding strength of the dendrites and glass matrix, and the strain-hardening exponent of the dendrites, are estimated based on literatures. Here, Ti...

in this research, the effect of wood species and particle size on mechanicalproperties of wood plastic composites (wpc) made of fir (abies alba) and beech(fagus orientalis l.) sawdust and high density polyethylene (hdpe) wereinvestigated. wood plastic composite (wpc) were made with 30% hdpe in abatch process at 185˚c, at two particle sizes of 40 mesh and 80 mesh. maleicanhydride polypropylene (...

This work studied the grindability of the multidirectional carbon fibre-reinforced plastic (CFRP) composites with the panel layup of [(0◦/90◦/45◦/−45◦)3]s. Focuses were on the chip formation, material removal mechanism, ground surface features and grinding force characteristics. The results were systematically compared with the unidirectional CFRP composites. It was found that the grinding forc...

In-situ dendrite/metallic glass matrix composites (MGMCs) with a composition of Ti₄₆Zr₂₀V₁₂Cu₅Be₁₇ exhibit ultimate tensile strength of 1510 MPa and fracture strain of about 7.6%. A tensile deformation model is established, based on the five-stage classification: (1) elastic-elastic, (2) elastic-plastic, (3) plastic-plastic (yield platform), (4) plastic-plastic (work hardening), and (5) plastic...