The fiber loop mirror based on a ring configuration is one of the devices in optical fibers most used in communications and sensors (Mortimore, 1988). The device is formed when the two output ports of a directional coupler are spliced. In this configuration, the two waves at the coupler outputs travel in opposite directions but following the same optical paths in an optical fiber ring, which as...

We present measurements of biomolecular binding reactions, using a new type of integrated-optical biosensor based on a planar directional coupler structure. The device is fabricated by Ag(+) - Na(+) ion exchange in glass, and definition of the sensing region is achieved by use of transparent fluoropolymer isolation layers formed by thermal evaporation. The suitability of the sensor for applicat...

In this paper a novel design of all-optical half-subtractor based on nonlinear directional coupler is proposed. By using four waveguides and appropriately adjusting the refractive indices and selecting the proper length of waveguides, halfsubtractor function can be obtained. The operation of this function is simulated by RSoft CAD-Layout (BeamPROP) simulator. The simulation results confirm the ...

We investigate the nonlinear parity-time (PT) symmetric coupler from a dynamical perspective. As opposed to linear PT-coupler where the PT threshold dictates the evolutionary characteristics of optical power in the two waveguides, in a nonlinear coupler, the PT threshold governs the existence of stationary points. We have found that the stability of the ground state undergoes a phase transition...

Results of a theoretical and experimental investigation into the variation of coupling efficiency with coupling angle are presented for various beam focusing conditions for an integrated optical grating coupler. This investigation shows that the acceptance angle of the grating coupler can be broadened, within a relatively large range and with a relatively small loss of coupling efficiency, by f...

We report on intensity-dependent switching in lithium niobate directional couplers. Large nonlinear phase shifts that are due to cascading detune the coupling between the coupler branches, which makes all-optical switching possible. Depending on the input intensity, the output could be switched between the cross and the bar coupler branches with a switching ratio of 1:5 and a throughput of 80%.

We present a two-photon fluorescence microscope based on a three-port single-mode optical fiber coupler. It is found that the coupler behaves as a low-pass filter that can deliver an ultrashort-pulsed laser beam of as much as 150 mW of power in the wavelength range from 770 to 870 nm as well as collect a two-photon fluorescence signal in the visible range. As a result of using the fiber coupler...

We study light-beam propagation in a nonlinear coupler with an asymmetric double-channel waveguide and derive various analytical forms of optical modes. The results show that the symmetry-preserving modes in a symmetric double-channel waveguide are deformed due to the asymmetry of the two-channel waveguide, yet such a coupler supports the symmetry-breaking modes. The dispersion relations reveal...

A tunable negative-tap photonic microwave filter using a cladding-mode coupler together with optical injection locking of large wavelength detuning is demonstrated. Continuous and precise tunability of the filter is realized by physically sliding a pair of bare fibers inside the cladding-mode coupler. Signal inversion for the negative tap is achieved by optical injection locking of a single-mod...

A novel polarization-sensitive optical coherence tomography (PS-OCT) system was developed using polarization maintaining (PM) optical fibers and fiber coupler to measure birefringence properties of samples. Polarization distortion due to PM fibers and coupler can be calibrated with different polarization states during two consecutive A-scans. By processing the analytical interference fringe sig...