In this study, molybdenum-copper/alumina nano composite was synthesized with mechano-chemical method using high energy planetary ball milling. The molybdenum oxide, copper oxide and aluminum powder were used as starting materials and reaction appeared to occur through a rapid combustion reaction process. The evaluation of powder particles after different milling times was studied by X-ray diffr...

The dynamic stability of the milling process is investigated through a single degree of freedom mechanical model. Two alternative analytical methods are introduced, both based on finite dimensional discrete map representations of the governing time periodic delay-differential equation. Stability charts and chatter frequencies are determined for partial immersion upand down-milling, and for full...

The effects of ball mill treatment (0, 2, 4, 6, 8, and 10 min) on the physicochemical and digestible properties of scallops (Chlamys farreri) protein (CFP) were investigated. The CFP particle size decreased with increasing ball-milling time. The content of free sulfhydryl (SH) of CFP increased from 13.08 ± 0.25 μmol/g protein to 18.85 ± 0.24 μmol/g protein when the ball-milling time increased f...

For time and cost saving reasons, the lowest surface roughness possible is sought in milling operations. High speed milling is recommended in order to minimise the amount of material to be removed in subsequent finishing operations, e.g. grinding, electrical discharge machining or manual polishing. Several roughness parameters are usually employed for the characterization of polished surfaces. ...

The morphological and microstructural changes during mechanical milling of Al powder mixed with 2.5, 5 and 10 wt.% Al2O3 particles were studied. The milling was performed in a planetary ball mill for various times up to 20 h. The produced composite powders were investigated using X-ray diffraction pattern (XRD) to elucidate the role of particle size, secondary phase content and milling time on ...

Nanocrystalline nickel ferrite (NiFe2O4) has been synthesized from a stoichiometric mixture of oxides NiO and α-Fe2O3 in a high energy planetary mill. A post milling annealing at 350 °C was used to improve the solid state reaction. The obtained powders were investigated by X-ray diffraction, magnetic measurements, scanning electron microscopy, X-ray microanalysis, differential scanning calorime...

Particle size reduction is a simple means to enhance the dissolution rate of poorly water soluble BCS-class II and IV drugs. However, the major drawback of this process is the possible introduction of process induced disorder. Drugs with different molecular arrangements may exhibit altered properties such as solubility and dissolution rate and, therefore, process induced solid state modificatio...

Mechanical alloying has recently attracted considerable attention as researchers strive to enhance nanocomposite properties and extend their utility. The process can be performed at room temperature and homogeneous nanocomposite powders can be produced. In this paper, we investigated the effect of different ball milling parameters and operating conditions (milling time, ball size, processing co...

This research is about manufacture nanopowder Bioceramics from local materials used Ball Milling for biomedical applications. Source materials for the manufacture of medicines are plants, animal tissues, microbial structures and engineering biomaterial. The form of raw material medicines is a powder before mixed. In the case of medicines, research is to find sources of biomedical materials that...

We have measured X-ray absorption near edge structure (XANFS) of mechanically alloyed YzFe and YFez system as a fundion of milling time. An amorphous phase is obtained by mechanical alloying for 100 hours in the YzFe system and for 500 hours in the YFez system. In both systems the intensity of Fe Is-4pn transition grows up significantly with increasing the milling time and approaches to that of...