Iron and magnesium are almost immiscible at ambient pressure. The low solubility of Mg in Fe is due to a very large size mismatch between the alloy components. However, the compressibility of Mg is much higher than that of Fe, and therefore the difference in atomic sizes between elements decreases dramatically with pressure. Based on the predictions of ab initio calculations, we demonstrate in ...

A lot of troilite reaction rim textures formed through sulfidation of FeNi alloy of kamacite and taenite with sulfur rich gas have been identified especially in C03 unequilibrated carbonaceous chondrites. Troilite formation through sulfidation of FeNi alloy of kamacite and taenite with sulfur rich gas in the solar nebula is expected from the reaction kinetics as well as from the equilibrium con...

Introduction: Stainless steel alloy used in orthodontics has elements such as iron - magnesium and chromium , which may be released due to corrosion in the mouth . The aim of this study was to evaluate the changes of these elements in the saliva of patients undergoing fixed orthodontic treatment. Methods: In a clinical study with simple non- random sampling , 1ml saliva of 11 patients (7 fem...

This paper provides a framework for optimization of Induction Hardening parameters by using Intelligent Techniques. Heat Treatment of Iron Alloy is carried out for improving Mechanical and Metallurgical properties like Ductility, Toughness, Hardness, and Tensile Strength etc. These properties play a important role for selection of material in Manufacturing Field. Induction Hardening on iron all...

The effect of lanthanum implantation on the early stage oxidation of Fe-18wt%Cr5wt%Al and Fe-l8wt%Cr-5wt%Al-Iwt%Hf alloys at 1100 OC has been investigated. I t was found that the reactive element enriched surfaces oxidized almost two times faster initially, and the scale that formed had a higher iron content. An extremely wavy scale/alloy interface developed in the early stage due to the accele...

In AA2618 aluminum alloy, the iron- and nickel-rich intermetallics formed during solidification are of great effect on the mechanical properties of the alloy at both room temperature and elevated temperatures. However, the solidification behavior of the alloy and the formation mechanism of the intermetallics during solidification of the alloy are not clear. This research fills the gap and contr...

in this paper, the reasons of damage water pumps parts of the air compressor cooling system were studied. to reach this goal, the works like preparing metallographic samples, evaluation of structure, investigation of mechanical properties, the alloy parts detection and chemical analysis of deposit and corrosion products collected from the parts were performed. according to studies and results o...

Al-5Mg-0.8Mn alloys (AA5083) with various iron and silicon contents were cast under near-rapid cooling and rolled into sheets. The aim was to study the feasibility of minimizing the deteriorating level of the harmful Fe-rich phases on the mechanical properties through refining the intermetallics by significantly increasing the casting rate. The results showed that the size and density of the in...

Softcomag 49AA alloy consisting of 49 wt per cent Fe, 49 wt. per cent Co and 2 wt per cent V is a soft magnetic alloy with a combination of very high saturation magnetisation and high magnetostriction and used for several aeronautical applications such as generators (stators and rotors), fixed iron moving armature units etc. Though this alloy is brittle in nature, it can be formed into hot roll...

We have investigated the phase relations in the iron-rich portion of the iron-silicon (Fe-Si) alloys at high pressures and temperatures. Our study indicates that Si alloyed with Fe can stabilize the body-centered cubic (bcc) phase up to at least 84 gigapascals (compared to approximately 10 gigapascals for pure Fe) and 2400 kelvin. Earth's inner core may be composed of hexagonal close-packed (hc...