gas mixing in a t-shape micro mixer has been simulated using the direct simulation monte carlo (dsmc) method. it is considered that the adequate mixing occurs when the mass composition of the species, co or n2, deviates below 1 % from their equilibrium composition. the mixing coefficient is defined as the ratio of the mixing length to the main channel’s height. as the inlet kn increases, while ...

Over the past decade much effort has been made to develop new carrier materials, more performant biocatalysts, and new types of bioreactors for waste gas treatment. In biofilters fungal biocatalysts are more resistant to acid and dry conditions and take up hydrophobic compounds from the gas phase more easily than wet bacterial biofilms. In the present study, a biofilter packed with a mixture of...

Supersonic separators have found extensive applications in dehumidification of natural gases since 2003. Unlike previous studies, which have investigated the inlet conditions and nozzle geometry of supersonic separators for pure fluids, the present study employed a combination of momentum, heat, and mass transfer equations along with Virial equation of state (EOS) to inspect the effect of inlet...

The intermediate fluid vaporizer (IFV) is a new kind of vaporizer for liquefied natural gas (LNG). A thermal model was established based on the energy balance among the three typical parts of IFV, namely, evaporator, condenser and thermolator, whose mutual coupling and constraints were fully considered. Calculation codes were developed to solve the energy balance equations, in which the formula...

in this paper, thermal effect of plasma arc welding is investigated, and temperature field of ferrite stainless steel is acquired. thermal effect of plasma arc and subsequently the generated temperature field in the work piece is the key for analysis and optimization of this welding process, which is the main goal of this paper. finite element simulation of welding process by simplec method and...

A supersonic separator has been introduced to remove water vapour from natural gas. The mechanisms of the upstream and downstream influences are not well understood for various flow conditions from the wellhead and the back pipelines. We used a computational model to investigate the effect of the inlet and outlet flow conditions on the supersonic separation process. We found that the shock wave...

Gas mixing in a T-shape micro mixer has been simulated using the Direct Simulation Monte Carlo (DSMC) method. It is considered that the adequate mixing occurs when the mass composition of the species, CO or N2, deviates below 1 % from their equilibrium composition. The mixing coefficient is defined as the ratio of the mixing length to the main channel’s height. As the inlet Kn increases, while ...

Cooling characteristics are given in terms of the variation of average blade temperature at mid-span with cooling-flow rate, Reynolds number, gas/cooling-air absolute temperature ratio, and, for the rotor, gas-stream incidence. Chordwise and spanwise variations of blade temperature are also presented. Measured pressure-drop characteristics indicate that in a gas-turbine engine, with the cooling...

The redox behaviour of Pd-based TWCs is studied under dynamic, cycling conditions (e.g. lambda oscillations) on a 50 millisecond scale. Pd temporal response to gas inlet mixture changes is governed by metal-promoter interface properties.

The tests were carried out with the spark timing adjusted to the maximum brake torquetiming in various equivalence ratios and engine speeds for gasoline and natural gas operations. In thiswork, the lower heating value of gasoline is about 13.6% higher than that of natural gas. Based on theexperimental results, the natural gas operation causes an increase of about 6.2% brake special fuelconsumpt...