Centrifugal compressors produce high pressure ratio and rotate at speeds. So, a tiny unbalance can produce severe vibration. In this paper, effects of impeller gap on rotor vibration in a high speed centrifugal compressor is investigated. For this purpose, a numerical and experimental analysis are carried out. The moving reference frame method in FLUENT software is used for modeling of geometri...

The sprint start lays a foundation to a good performance of track athletes. Thus, the aim was to understand the key force production determinants of the athletics sprint start. Eleven male athletes performed normal sprint starts with ground reaction forces collected at 1000 Hz from under each extremity separately. Key kinetic variables were analysed from six starts from each athlete and correla...

In pushing and pulling wheeled carts, the direction of force exertion may, beside the force magnitude, considerably affect musculoskeletal loading. This paper describes how force direction changes as handle height and force level change, and the effects this has on the loads on the shoulder and low back. Eight subjects pushed against or pulled on a stationary bar or movable cart at various hand...

the previous studies show that a high percentage of traffic accidents take place in two-lane rural highways and most of which happen at horizontal curves. meanwhile the horizontal alignment is often subject to hard topographic conditions where because of economic aspects designers are forced to design horizontal curves at grades. vertical angle of longitudinal slope reduces the normal force of ...

In this research we developed an orthodontic simulator for analysis of orthodontic forces distribution in the case of the continuous arch technique. In order to take into account vertical force, besides horizontal force and occlusogingival moment on instrumented artificial tooth, tooth root was designed as a ring load cell. Fixing each artificial tooth onto combined mechanical stages enabled va...

The external forces applied in swimming starts have been often studied, but using direct analysis and simple interpretation data processes. This study aimed to develop a tool for vertical and horizontal force assessment based on the swimmers' propulsive and structural forces (passive forces due to dead weight) applied during the block phase. Four methodological pathways were followed: the exper...

Sixteen semiprofessional Australian football players performed running bouts at incremental velocities of 40, 60, 80, and 100% of their maximum velocity on a Woodway nonmotorized force treadmill. As running velocity increased from 40 to 60%, peak vertical and peak horizontal forces increased by 14.3% (effect size [ES] = 1.0) and 34.4% (ES = 4.2), respectively. The changes in peak vertical and p...